Metra 95-9114B Dash Kit Instruction Manual
- June 4, 2024
- Metra
Table of Contents
Metra 95-9114B Dash Kit
KIT COMPONENTS
- A) Radio trim panel
- B) Radio housing
- C) (4) Panel clips
- D) (8) ISO screws
KIT FEATURES
- ISO DDIN radio provision
- Painted scratch-resistant matte black
- Location to retain the factory passenger airbag light
WIRING & ANTENNA CONNECTIONS (sold separately)
- Wiring Harness: XSVI-9004-NAV
- Antenna Adapter: 40-EU56
TOOLS REQUIRED
- Panel removal tool
- Phillips screwdriver
- Socket wrench
- Metra 86-9001 radio removal tools (qty. 2)
Attention!
Let the vehicle sit with the key out of the ignition for a few minutes before
removing the factory radio. When testing the aftermarket equipment, ensure
that all factory equipment is connected before cycling the key to ignition.
DASH DISASSEMBLY
- Insert (4) of the Metra 86-9001 radio removal tools into the slots on the front of the radio face, and then remove the radio. (Figure A)
- Unplug the airbag light, then unsnap and remove it from the factory radio. Continue to Kit Assembly
KIT ASSEMBLY
ISO DDIN radio provision
-
Attach the (4) supplied panel clips to the radio trim panel. (Figure A)
-
Attach the radio housing to the radio using screws supplied with the radio. (Figure B)
Note: The radio mounting screws must be flush in the brackets so the radio assembly will fit into the dash opening. Screws have been provided in the event they were not provided with the aftermarket radio. -
Locate the factory wiring harness and antenna connector in the dash, and complete all necessary connections to the radio. Metra recommends using the proper mating adapter from Metra and/or AXXESS. Test the radio for proper operation.
-
Slide the radio/radio housing assembly into the dash opening paying close attention to the guides on the radio housing and the slots in the dash opening.
Note: Be sure to keep the passenger airbag light plug accessible while mounting the radio into the dash. -
Snap the radio trim panel over the radio and reassemble the dash in reverse order of disassembly.
Note: Snap the factory airbag light in from the front, then plug the airbag light in while snapping the radio trim panel over the radio.
INSTALLATION INSTRUCTIONS
If you are having difficulties with the installation of this product, contact our Tech Support line either by phone at 386-257-1187 or by email at techsupport@metra-autosound.com. Before doing so, look over the instruction booklet a second time and ensure that the installation was performed exactly as the instruction booklet stated. Have the vehicle apart and ready to perform troubleshooting steps before contacting Metra/Axxess Tech Support.
KNOWLEDGE IS POWER
Enhance your installation and fabrication skills by enrolling in the most
recognized and respected mobile electronics school in our industry. Log onto
www.installerinstitute.com or call
800-354-6782 for more information and
take steps toward a better tomorrow.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>