PURGEAR STC-1000 Digital Thermostat User Guide

June 4, 2024
PURGEAR

PURGEAR STC-1000 Digital Thermostat

STC-1000 thermostat offers two relays to wire one refrigerator and one heater; it will auto-switch between the heating and cooling mode; that’s why it was taken as “All-Purpose Temperature Controller.”

Wiring Diagram

PURGEAR STC-1000 Digital Thermostat-1

This unit does not output AC electricity; hence you have to wire all live and null wires to each port; you may use the jumper wire conveniently.

Function Menu

Code Function
F1 Temperature Setpoint
F2 Temperature Hysteresis /
F3 Protection Delay Time for the
F4 Temperature Calibration
Set the Aimed  Temp  Range

The aimed temperature range was defined from “F1 – F2” (if lower than this, trigger heating) to “F1 + f2” (if higher than this, trigger cooling), hence you need to set both “F1” and “F2”.

Configure Parameters

The aimed temperature range was defined from “F1 – F2” (if lower than this, trigger heating) to “F1 + f2” (if higher than this, trigger cooling), hence you need to set both “F1” and “F2”.

  1. Hold the key for 3s to enter the menu list; the display shows the code F1;
  2. Press the key to see the existing value, press direction keys to change it;
  3. Press the key to save data.

Attention: the new data will be discarded and back to normal status if without operation in 8 seconds.

More Tips

Under normal status

  •  Press the key to check the temperature set-point F1;
  • Press the key to check the Hysteresis value F2;
  • Hold the key for 3s to power off / on;
  • Hold the  and keys at the same time for 5s to restore factory settings.

This is not a step-by-step user manual;
It just shows the key points.
The new user should read the Full-Content Version User Manual

Haswill Electronics
STC-1000 Thermostat
Copyright Haswill-Haswell All Rights Reserved

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals