CRUTCHFIELD 70-5520 Receiver Wiring Adaptor Owner’s Manual
- June 4, 2024
- CRUTCHFIELD
Table of Contents
CRUTCHFIELD 70-5520 Receiver Wiring Adaptor
Receiver Wiring Adaptor
IMPORTANT
Before starting, compare items on your invoice with items received. Carefully
check packing materials. If an item is missing, please call Crutchfield at
1-888-955-6000.
CONNECT WIRES
- Connect wires below to the matching function of each wire on your receiver supplied with receiver.
- The wire colors of your new receiver may, or may not, match the wire colors of the adaptor.
- Match adaptor and receiver wires by function, disregarding color.
- If your receiver does not have an Illumination wire, tape off the Orange wire.
- Connect Black wire to Ground wire of new receiver.
- Individually tape off any unused wires.
- Make final connections following.
These notes pertain to 2006-’08 Hyundai Sonatas only. This Blue
Wire is used as the Amp Remote lead in 2006-08 Hyundai. Sonatas with a factory
subwoofer, but will not be used if the vehicle does not have a subwoofer. For
all 2006-08 Hyundai Sonatas: Connect the Power Antenna Wire on the new
receiver to the factory Green/Black Wire matching this location bottom of
illustration on the factory harness disconnected from the factory radio.
Tools & Parts Required
Wire Stripper/Crimp Tool
Crimp Caps
CRIMP CONNECTIONS
Strip wires back 1/2
Twist wires together and insert in crimp cap
Squeeze middle of cap for tight connection
Complete crimp connections for all necessary wires. Be sure to wrap any wires from the Wiring Adaptor that are not necessary wires with no match from the new receiver with electrical tape.
APPLICATION
When ready to install the receiver, plug the Wiring Adaptor from the new receiver or receiver assembly into the factory radio harnesses in the vehicle dash.
Generic Illustration
