HARBOUR 93 Litre Beverage Chiller User Guide
- June 4, 2024
- HARBOUR
Table of Contents
HARBOUR 93 Litre Beverage Chiller
Installation & First Use
Before installing your new Beverage Chiller, please read all safety instructions in the user manual.
Place the Beverage Chiller on a sturdy, level floor for quiet operation. If it is to be placed on carpet, support it with a wooden board underneath. This appliance is designed to be freestanding only and should not be recessed or built in.
Before turning on your appliance for the first time:
- The beverage chiller must be rested for at least half an hour before connecting power.
- Clean the inner chamber with lukewarm water and a soft cloth.
- Do not connect the cooler to an electronic energy-saving plug and converter that can convert DC into AC (E.g.: solar energy system. ship grid).
- Condensation or frost will form on the rear of the wine cooler when the compressor is running. This is a normal function of a cooler. Wiping away the frost or condensation is not required as it will eventually evaporate. The defrosted water will be collected into a drain tank and then flow into a water disposal pan above the compressor before evaporating.
Operating the Beverage Chiller
You can set and adjust the temperature in the cabinet to anywhere within the cooling range (5º C – 18º C) using the Thermostat Knob.
- “Normal”: warmest setting
- “Cold”: colder setting
- “Colder”: coldest setting
The “Off” setting turns the Beverage Chiller off. The selected setting should be pointed to the top of the dial.
For an overview and more information on your Beverage Chiller, please see pages 10–11 of your User Manual.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>