KEMI MOTO B0801-00305CL Accent Light Owner’s Manual

June 4, 2024
KEMI MOTO

KEMI MOTO B0801-00305CL Accent Light

BEFORE YOU BEGIN

  1. Please read the instructions carefully and verify that each item is in the list.
  2. Please retain these installation instructions for further reference and parts ordering information.

IMPORTANT

  1. Please read the installation instructions carefully before you start.
  2. If the vehicle is clean and free of other debris, it will be easy to install.
  3. For your safety and to ensure a satisfactory installation, please complete all the installation steps in the order shown below.

PRODUCT INFORMATION

  1. Accent Light x1

INSTALLATION TIPS

  1. Press down the two tabs [A] on top of the grille [B], tilt the grille slightly outwards, then remove the front grille [B].

  2. Remove trim [C] from front fascia by removing four retained nuts [D].

  3. Locate the harness connector [E] and connect it to accent light.

  4. Connect the yellow wire (+) of accent light [1] to left turn signal light control harness and the green wire (+) to right turn light control harness.
    NOTE: The turn signal light control kit is not included in our product. You need to provide by yourself.

  5. Install accent light [1] to fascia by four retained nuts [D].

  6. Reinstall the grille [B] and finish installation.

  7. Scan the QR code on the controller [3], download the control APP, then open the APP and connect to Bluetooth to control the RGB lights.

KEMIMOTO APP

FCC RADIATION EXPOSURE STATEMENT

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body

FCC Statement

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment

CUSTOMERS SUPPORT

K www.kemimoto.com
K Designed by Kemimoto Group
K Kemimoto All Rights Reserved, Infringement must be prosecuted.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals