MeTra 95-7640B TurboTactile Dash Kit Installation Guide Installation Instructions Kit Features Kit Components Dash Disassembly Kit Preparation

June 1, 2024
Metra

Installation Instructions

95-7640B

Infiniti G37 2008-2013

Wiring & Antenna Connections

Wiring Harness: Included with kit
Antenna Adapter: 40-NI12 Included with kit

Tools Required

  • Panel removal tool
  • Phillips screwdriver
  • Socket wrench

Kit Features

  • Factory-style hard buttons with laser etched graphics and rotary knobs retain and allow control of climate functions shown on an included 7-inch touch screen display
  • Designed for most DDIN radio installations in the lower dash location
  • A shallow mount or modular radio can be installed in the upper dash location.
  • Integrated hazard button and passenger airbag indicator light
  • Retains audio controls on steering wheel and back-up camera when equipped
  • Painted scratch resistant matte black
  • Supported Languages include English, Spanish and French

Note: The clock and compass in the driver’s information center will no longer be functional.

Kit Components

  • A) Upper panel
  • B) Upper brackets
  • C) Lower panel
  • D) Lower brackets
  • E) Touch screen
  • F) Touch screen brackets
  • G) Bottom trim panel
  • H) White panel clips (2)
  • I) Metal panel clips (2)
  • J) #8×3/8″ truss-head Phillips screws (2)
  • K) #8×3/8″ pan-head Phillips screws (8)

Not Shown: Antenna adapter and harnesses

Dash Disassembly

2008-2009 vehicles:

  1. Slide the shifter boot down and remove clip holding shifter knob and remove shifter knob. (Figure A)
  2. Unclip and remove shifter boot trim panel. (Figure B)

Continued on next page

2010-2013 vehicles:

  1. Unclip and remove the trim panel from below the factory radio controls.
    (Figure A)

Continued on next page

2008-2013 vehicles:

  1. Remove (2) screws at the bottom of the radio/climate control panel and remove panel. (Figure C)
  2. Remove (2) screws at the bottom of the factory display panel and remove panel with the vents. (Figure D)
  3. Remove the factory vents and save them for Kit Assembly.
  4. Remove (4) Phillips screws securing the radio chassis and a/c amp bracket assembly then remove the assembly from the dash. (Figure E)
  5. Remove (2) Torx screws securing the a/c amp module to the radio chassis/ bracket assembly and save for Kit Assembly. (Figure F).

Important Note: The A/C amp module must be re-installed and connected for the vehicle to operate correctly.
Continue to Kit Preparation

Kit Preparation

  1. Snap the factory vents into the upper panel. (Figure A)
  2. Attach the (2) supplied panel clips to the lower panel. (Figure B)
  3. Secure the touch screen brackets to the touch screen using the supplied #8 x 3/8” pan head screws. (Figure C)
  4. Attach the (2) supplied panel clips to the bottom trim panel. Note: factory bottom trim panel can be used if desired. (Figure D)

Continue to Kit Assembly

Full size DDIN mounting in the lower location

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals