PHILIPS BWP150 SmartBright LED Tunnel Instruction Manual
- June 4, 2024
- Philips
Table of Contents
PHILIPS BWP150 SmartBright LED Tunnel
SPECIFICATION
Mount luminaires
- 2-M8 Screw Torque 17.Nm
- 2-M8 20N.m
Mount Luminous, 4-M10 Screw Torque 20N.m4-M1020N.m
Two slot holes must be fixed by screw and washer when installing, outer dimension of washer must be larger than 14mm
Luminaire Wiring
Class I luminaire, external earthing is must required, and the length of earth
must be longer than L and N.
The insulation type between the signal terminal and the power terminal is
basic insulation.
Power Cable
Dimming Cable
-
In some cases referred to as Earth Leakage Current.
- The connection of power cable on luminaire is type Y. The Luminaire should be installed by a qualified electrician and wired in accordance with the latest IEC-60364-7-714 regulations.
- Switch off electricity supply (mains) before operation.
- Before using, external earthing is must required. Earthing is also must required in its whole life.
- The luminaire should be replaced immediately if any crack or deterioration.
- The luminaire shall be installed by a qualified electrician and wired in accordance with the latest IEEE electrical regulations or the national requirements.
- The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person.
- The power supply source should be equipped with Surge protection device. such device should be installed at the power distribution
Read User Manual Online (PDF format)
Loading......