EZ-Flo 15074 Adjustable Bath Tub Spout with Face Bushing Installation Guide
- June 1, 2024
- EZ-Flo
Table of Contents
EZ-Flo 15074 Adjustable Bath Tub Spout with Face Bushing
Tools and Supplies
- Pipe Joint tape
Installation Instructions
Step 1
Make sure that your new spout is the same length as your old one to avoid having to adjust the pipes or use an adapter.
- If you have a Front-end threaded spout, measure from the wall to the end of the nipple to get the appropriate size.
- If you have a Wall-end threaded spout with a face bushing, your threaded nipple should be a maximum of 1/211 in length.
- If you have an Adjustable threaded spout, your nipple should be a maximum of 1-3/811 in length.
Step2
Apply approximately 4-6 wraps of Teflon tape.
Step3
Apply silicone caulking around the edge of where the pipe meets the wall to prevent water from dripping behind the spout and into the shower wall.
Step4
Thread the spout onto the pipe. Start slowly so as not to cross threads. Tighten until snug and line up the spout vertically with the rest of the fixtures.
Customers Support
For more information, please visit ez-flo.net
Customer Service: Bn-700-4242
Documents / Resources
| EZ-
Flo 15074 Adjustable Bath Tub Spout with Face
Bushing
[pdf] Installation Guide
15074, 15084, 15074 Adjustable Bath Tub Spout with Face Bushing, Adjustable
Bath Tub Spout with Face Bushing, Bath Tub Spout with Face Bushing, Tub Spout
with Face Bushing, Face Bushing
---|---