EZ-Flo 15080 Tub Spout with Diverter Instruction Manual
- June 15, 2024
- EZ-Flo
Table of Contents
EZ-Flo 15080 Tub Spout with Diverter
Tools and Supplies
- Adjustable Pliers
- Thread Tape
Installation Instructions
Note: This device is designed in compliance with ASME All2.18.l/CSA 8125.1 standards. A small amount of water is intended to flow from the spout when the diverter is engaged. This is a safety feature to help prevent unintended release of water.
Turning counterclockwise, remove old tub spout (A). 1/2″ Threaded Connection
- Remove all debris from the threaded end of Stub Out Nipple (8). Turning clockwise, wrap two to four turns of Thread Tape onto threaded end of Stub Out Nipple (8).
- Turning clockwise, hand tighten new Tub Spout (A) onto Stub Out Nipple (8).
- Turn shower “On”. Test for leaks. Caution: do not use if leaking from rear. Wall damage can occur.
- For more information, please visit ez-flo.net
- Customer Service: Bn-700-4242
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>