LIEBHERR F 913 Static Cooling Counter Top Freezer Instruction Manual

June 3, 2024
LIEBHERR

LIEBHERR F 913 Static Cooling Counter Top Freezer

LIEBHERR-F-913-Static-
Cooling-Counter-Top-Freezer

Safety instructions and warnings

  • CAUTION: This appliance is not intended for use by persons (including children) with reduced physi-cal, sensory or mental capabilities or lack of experi-ence and knowledge, unless they have been given supervision or instruction concerning use of the ap-pliance by a person responsible for their safety.
  • CAUTION: Children should be supervised to en-sure that they do not play with the appliance.
  • CAUTION: Maximum loading for each shelf is 30kg only!
  • WARNING: If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
  • CAUTION: Do not store explosives substances such as aerosol cans with flammable propellant in this appliance.
  • CAUTION: The appliance contains flammable ma-terials and should be handled, serviced and dis-posed of properly.
  • WARNING: Keep clear of obstruction all ventila-tion openings in the appliance enclosure or in the structure for building-in.
  • WARNING: Do not use any mechanical devices or other artificial aids for defrosting other than those recommended by the manufacturer.
  • WARNING: Do not damage the refrigerant circuit.
  • WARNING: Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer.
  • This appliance can be used by children of 8 years and above, and also by persons with reduced phys-ical, sensory or mental capabilities or lack of expe-rience and knowledge, if they are supervised or have been instructed on safe use of the appliance and understand the resulting risks. Children must not allow to play with the appliance. Cleaning and user maintenance must not be carried out by chil-dren without supervision.
  • To prevent injury or damage to the unit, the appli-ance should be unpacked and set up by two people.
  • In the event that the appliance is damaged on de-livery, contact the supplier immediately before con-necting to the mains.
  • To guarantee safe operation, ensure that the appli-ance is set up and connected as described in these operating instructions.
  • Disconnect the appliance from the mains if any fault occurs. Pull out the plug, switch off or remove the fuse.
  • When disconnecting the appliance, pull on the plug, not on the cable.
  • Any repairs and work on the appliance should only be carried out by the customer service department, as unauthorised work could prove highly danger-ous for the user. The same appliesto changing the mains power cable.
  • Do not allow naked flames or ignition sources to enter the appliance. When transporting and clean-ing the appliance ensure that the refrigerant circuit is not damaged. In the event of damage, make sure that there are no ignition sources nearby and keep the room well ventilated.
  • Do not stand on the plinth, drawers or doors or use them to support anything else.
  • Avoid prolonged skin contact with cold surfaces or chilled/frozen food. This could cause pain, numb-ness and frostbite. In the case of prolonged skin contact, protective measures should be taken, e.g. gloves should be worn.
  • Do not consume food which has been stored for too long, as it could cause food poisoning.
  • Electrical components might cause leaking gas to ignite. You may identify such sprays by the printed or a flame symbol.
  • If you have a lockable appliance, do not keep the key near the appliance or within reach of children.
  • The appliance is designed for use in enclosed ar-eas. Do not operate the appliance outdoors or in areas where it is exposed to splash water or damp conditions.
  • When transporting or operating the appliance at an altitude of more than 1500 m above sea level, the glass pane in the door can break due to the reduc-tion in air pressure. Broken fragments are sharp-edged and can cause serious injury.

Range of appliance use

This appliance may be used for displaying food, including beverages, for retail sale. Commercial use means for ex-ample their use in restaurants, canteens, hospitals and in commercial establishments such as bakeries, butchers, supermarkets, etc.

Foreseeable misuse:
Do not use the appliance for the following applica-tions:

  • Storage and cooling of :
    • Chemically unstable, combustible or corrosive substances.
    • Medicines, blood plasma, laboratory prepara-tions or similar substances and products based on Directive 2007/47/EC on medical devices.
  • Use in hazardous areas.
  • Use outdoors or in damp and splashing water areas.

Improper use of the appliance leads to damage or spoil-age of the stored goods.
The cabinet is intended to store and to display pre-frozen and pre-packed ice- cream as well as packed foodstuff. Access by the customer is achieved by opening a non-transparent or transparent lid from the top.
Do not store explosive substances in the device, such as aerosol containers with flammable propellant gas.

Dimensions:

  • Height : 816 mm
  • Width : 497 mm
  • Depth : 548 mm

Description of the appliance

LIEBHERR-F-913-Static-Cooling-Counter-Top-
Freezer-2

Climate rating
The climate class [X] specifies the ambient conditions in which the ap-pliance can be operated safely.
The climate class [Y] and temperature class [Z] define the maximum outline conditions in which the appliances will operate perfectly.

[X]

Climate rating

| Max. room temperature| Max. relative humidity
---|---|---
4| 30°C| 55%
7| 35oC| 75%

Do not operate the appliance outside the specified room temperature range..

[Y]

Climate class

| Temperature [°C]| Relative humi- dity

[%]

---|---|---
0| 20| 50
1| 16| 80
8| 24| 55
2| 22| 65
3| 25| 60
4| 30| 55
6| 27| 70
5| 40| 40
7| 35| 75

Recommended temperature setting:

[Z]

Temperature class

|

Temperature setting [°C]

---|---
L1| -18
L2| -18
L3| -15
M0| +4
M*| 6
M1| +5
M2| +7
H1| +10
H2| +10

Additional information

  • Food will remain fresh for longer if stored at the correct tem-perature. This can prevent having to discard food needlessly.
  • If the condenser coil is not cleaned every year, it will significantly reduce the appliance’s efficiency.
  • The period during which spare parts, necessary for the repair of the refrigerating appliance with a direct sales function, are available is 10 years.
  • The minimum duration of the guarantee of the refrigerating appliance with a direct sales function offered by the manufac-turer, importer or authorised representative is 2 years.

EPREL database:
As from 1 March 2021, information about energy labelling and ecodesign requirements will be available in the European product database (EPREL). You can access the product database using the following link: https://eprel.ec.europa.eu/. You will be asked to enter the model identifier. You will find the model identifier on the type plate.

Setting up

  • Do not place the appliance in direct sunlight or near cookers, radiators and similar sources of heat.
  • The floor on which the appliance stands should be horizontal and level.
  • Compensate for uneven floors with the adjustable feet.
  • ATTENTION: There must be a gap of at least 10 cm between the side enclosure (left and right) and rear enclosure of the appliance against the wall.
  • Always ensure there is good ventilation and that the outward flowing air is able to escape. Always install the appliance directly against the wall.
  • Do not cover ventilation openings or grille.
  • Standard EN 378 specifies that the room in which you install your appliance must have a volume of 1 m3 per 8 g of R 600a / R 290 refrigerant used in the appliance, so as to avoid the formation of inflammable gas/air mixtures in the room where the appliance is located in the event of a leak in the refrigerant circuit. The quantity of refrigerant used in your appliance is indicated on the type plate on the inside of the appliance.

Electrical connection

  • Only operate the appliance with alternating current (AC).
  • The permissible voltage and frequency are indicated on the type plate. The position of the type plate is shown in the section entitled Description of the appliance.
  • The socket must be properly earthed and protected by a fuse.
  • The tripping current of the fuse must be between 10 A and 16 A.
  • The socket must not be situated behind the ap-pliance and must be easily accessible.
  • Do not connect the appliance using an ex-tension cable or extension socket.
  • Do not use stand-alone inverters (conversion of direct current to alternating current / three phase current) or energy-saving plugs. Risk of damage to the electronic control system!

Switch the appliance on and off

  • You are recommended to clean the appliance before switching it on for the first time. The appliance is deliv-ered ready for use and wired for normal operation. When it is connected up, the appliance is ready for operation.

To switch the appliance on
Connect the appliance to the mains – the appliance is switched on.

To switch the appliance off
Pull out the mains plug – the appliance is switched off.

Important When the temperature control is turned to “•“, the refrig- eration system is switched off, but the appliance is not completely disconnected from the mains.

Setting the temperature

Using a coin, turn the arrow of the temperature control T to a setting between 1 and 7.
Setting 1 = highest temperature
Setting 7 = lowest temperature

Temperature display

The thermometer is located on the left of inner compartment.LIEBHERR-F-913
-Static-Cooling-Counter-Top-Freezer-6

Lighting
LED lighting is installed to illuminate the appliance inte-rior.
CAUTION: The light intensity of the LED light corre-sponds to laser class 1M:

  • When cover is removed, do not look directly at the light through optical instruments. Sever eye injury can occur.
  • The lighting may only be replaced by the customer service technician or by competent skilled person-nel!
  • Do not try to change the LED strips yourself!

Noise emissions from the appliance
The noise level while the appliance is operating below 70 dB (A) (relative noise level 1pW).

Brightness Control

To adjust the brightness of the LED strips:

  • Insert something (coin, screwdriver etc) into knog slot.
  • Turn clockwise for brighter illumination.
  • Turn anti-clockwise for dimmer illumination

Note: Only applicable for appliance with dimmer.

Safety lock

The lock is equipped with a safety mechanism.
Locking the appliance:

  1. Insert the key.
  2. Push and turn the key 90o counterclockwise.

To unlock the appliance, the same procedure must be repeated in the same order.

Defrosting

When operating at the coldest thermostats setting, the interior wall may ice up. In this case the appliance must be defrosted manually by:

  • Remove the goods from the appliance and store in a cool place.
  • Switch off the appliance by pull out the main plug.
  • Leave the door of the appliance open while defrosting. After defrosting, mop up the remaining water and clean the appliance.
    Do not use any mechanical devices or other artificial aids for defrosting other than those recommended by the manufacturer.

Cleaning

Cleaning the appliance at least twice per year. Before cleaning always switch off the appliance. Pull out the mains plug or switch off.

  • Clean the inside, equipment and outer walls with luke-warm water and a little detergent. Do not use abrasive or acid cleaners or chemical solvents.
  • Ensure that no cleaning water penetrates into the elec-trical components or ventilation grille.
  • The dust should be removed from the refrigeration unit and heat exchanger – metal grid at the back of the ap-pliance once a year.
  • Clean the drain hole in the refrigerator compartment with a thin object, e.g. cotton swab or the like.
  • Do not damage or remove the type plate on the inside of the appliance. It is very important for servicing pur-poses.
  • Do not use steam cleaners because of the risk of injury and damage.

Shutting your appliance down
If your appliance is to be shut down for any length of time, switch it off by disconnect the plug or unscrew the fuse. Clean the appliance and leave the door open in order to prevent unpleasant smells.
The appliance complies with the relevant safety regula-tions and EC Directives 2004/108/EC and 2006/95/EC.

Disposal notes
The appliance contains reusable materials and should be disposed of properly – not simply with unsorted household refuse. Appliance which are no longer needed must be disposed of in a pro-fessional and appropriate way, in accordance with the current local regulations and laws.
When disposing of the appliance, ensure that the refrigerant circuit is not damaged to prevent uncontrolled escape of the refrigerant it contains (data on type plate) and oil.

  • Disable the appliance.
  • Pull out the mains plug.
  • Cut through the connection cable.

WARNING Danger of suffocation due to packing material and plastic film!
Do not allow children to play with packaging material. Take the packaging material to an official collection point.

Malfunctions

If a malfunction occurs during operation, check whether it is due to an operating error. You may be able to rectify the following faults yourself:

Appliance does not function:

  • Is the appliance switched on?
  • Is the plug correctly fitted in the mains socket?
  • Is the fuse intact?

Loud running noise:

  • Is the appliance set up firmly on the floor?
  • Does the appliance cause nearby items of furniture or objects to vibrate? Please note that noises caused by the refrigerant circuit cannot be avoided.

The temperature is not low enough:

  • Is the temperature setting correct (see “Setting the temperature”)?
  • Have the excessive amounts of fresh food been placed in the appliance?
  • Does the separately installed thermometer show the correct reading?
  • Is the ventilation system working properly?
  • Is the appliance set up too close to a heat source?

If none of the above causes apply and you cannot rectify the fault yourself, contact the nearest customer ser- vice department stating the type designation (1), service number (2) and appliance number (3) as indicated on the type plate. The position of the type plate is shown in the section entitled Description of the appliance.

No.7 Jln Firma 2 , Kaw.Perind.Kluang ll, KM7, Jln Mersing, 86007 kluang, Johor, West Malaysia. www.liebherr.com.my

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals