VISUAL COMFORT Foxdale 5, 9 Light and 6 Light Linear Chandelier Instruction Manual
- June 12, 2024
- VISUAL COMFORT
Table of Contents
VISUAL COMFORT Foxdale 5, 9 Light and 6 Light Linear Chandelier Instruction
Manual
GENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant junctionboxes.
This product is safety listed for damp locations. Incandescent version may be dimmed with a standard incandescent dimmer. LED version may be dimmed with a LED dimmer. Consult lamp manufacturer for additional information.
This instruction shows a typical installation.
CAUTION RISK OF FIRE –
This product must be installed in accordance with the applicable installation
code by a person familiar with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors
SAVE THESE INSTRUCTIONS!
Install the Fixture
-
Feed the fixture wires through the main stem and screw it to the fixture.
-
Install the cup onto the bottom of the fixture and secure it in place with the finial.
-
Determine the wanted height or look of the fixture with the provided stems, hang straight and/or link and loop, and assemble them by screwing them together.
NOTE: Use hang straight for standard ceilings and use link and loop for sloped ceilings. -
Feed the fixture wires through the stem assembly and screw it to the main stem.
-
Unscrew the collar nut off the screw collar and slide it onto the stem assembly, followed by the canopy.
-
Feed the fixture wires through the threaded nipple and screw the mounting plate assembly onto the hang straight or link and loop.
-
Align and secure the mounting plate to the junction box.
-
Connect the fixture to a suitable ground in accordance to local electrical codes.
-
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
-
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
-
Neatly place all the wires into the junction box, place the canopy onto the ceiling and secure it in place with the collar nut.
-
Place the candle tubes over the sockets, followed by the shades.
-
Screw the lamps into the sockets. Refer to the label on the socket for Max Wattage Information.