Schneider NHA56713-02 PowerPacT B Frame Molded Case Circuit Breakers User Guide
- June 13, 2024
- Schneider
Table of Contents
NHA56713-02 PowerPacT B Frame
Molded Case Circuit Breakers
User Guide
NHA56713-02 PowerPacT B Frame Molded Case Circuit Breakers
**
Lug kits
**
|
---|---
NHA56713-02|
https://www.se.com/us/en/download/document/NHA56713/
PowerPacT B-Frame
DOCA0094EN / DOCA0095EN
www.se.com>support>…/
chneider Electric Customer Support
Retain instructions for future use.
Visit our website at: www.se.com to download the
documents
listed above (user guides or instructio sheets ) and other documents.
PLEASE NOTE
- Electrical equipment should be installed, operated, serviced, and maintained only byqualified personnel.
- No responsibility is assumed by Schneider Electric for any consequences arising out of the use of this material.
- All pertinent state, regional, and local safety regulations must be observed wheninstalling and using this product.
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION OR ARC FLASH
- Apply appropriate personal protective equipment (PPE) and follow safe electrical work practices. See NFPA 70E, CSA Z462, NOM 029-STPS-2011 or local equivalent.
- This equipment must only be installed andserviced by qualified electrical personnel.
- Turn off all power supplying this equipment before working on or inside equipment.
- Always use a properly rated voltage sensing device to confirm power is off.
- Replace all devices, doors, and covers before turning on power to this equipment.
- Beware of potential hazards, and carefullyinspect the work area for tools and objects that may have been left inside the equipment.
Failure to follow these instructions will result in death or serious injury.
WARNING : This product can expose you to chemicals including lead and lead compounds, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to: www.P65Warnings.ca.gov.
Required for Installation
Description
Field-installable lug kits:
A EverLink™ lug
B EverLink™ lug with control wire terminal
C Mechanical lug
D Compression lug / busbar
Before Working on Equipment
- Turn off all power supplying this equipment before working on or inside equipment.
- Turn off or use push-to-trip button to trip circuit breaker.
- Use a properly rated voltage sensing device to confirm power is off.
Remove Green Cap
Remove Lugs
Install Lugs
Install Green Cap
Device Identification
Wiring
9.1 EverLink Lugs Connections
1 For
IEC applications, only copper wires allowed
9.2 Mechanical Lug Connections
NOTICE
HAZARD OF OVERHEATING
Do not allow wire strands to get caught in wire binding screw threads.
Failure to follow these instructions can result in equipment
damage. 9.3 Compression Lugs
Schneider Electric USA, Inc.
35, rue Joseph Monier
CS30323
92500 Rueil-Malmaison
France
www.se.com/us
NHA56713
© 2016-2023 Schneider Electric – All rights reserved
Documents / Resources
|
Schneider NHA56713-02 PowerPacT B Frame Molded Case Circuit
Breakers
[pdf] User Guide
NHA56713-02 PowerPacT B Frame Molded Case Circuit Breakers, NHA56713-02,
PowerPacT B Frame Molded Case Circuit Breakers, Frame Molded Case Circuit
Breakers, Molded Case Circuit Breakers, Case Circuit Breakers, Breakers
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>