REKKORD M 600 Audiophile Sub Chassis Turntable User Manual

: May 15, 2024
: REKKORD

Table of Contents

Safety precautions
PRODUCT ANSTRUCTION
Preliminary operations
Connecting the power supply
Connection to amplifier or receiver
Balancing the tonearm and setting the tracking and antiskating force –
Height adjustment oft tonearm
Manuel start, speed selection 33/45/78, tone arm lift
Switch off
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

**REKKORD M 600 Audiophile Sub Chassis Turntable User Manual

**

Safety precautions

CAUTION!
To prevent the risk of fire or electrical damage, do not expose the device to moisture or rain. Do not expose the device to direct sunlight or heat! Please do not open the device!
Keep the packaging material, such as plastic foils, away from children. Danger of asphyxiation by misuse

Disposal of electrical appliances by consumers in private households within the EU
At the end of its lifetime, do not throw the device away with the normal household waste. Ask about the options for environmentally sound disposal at the local authorities, at recycling centers, or where you purchased the device.

This product complies with applicable EU regulations.

PRODUCT ANSTRUCTION

Preliminary operations

Unpack the unit and all accessories. Please keep the packaging for future use when transporting the device

Place the belt (2), Platter (3) and Felt mat in position.

Connecting the power supply

The delivered power supply will be connected to the socket (12). The power supply, corresponding to the voltageindicatior on the nameplate, has to be plugged into a power supply plug either with 230 V /5 0 Hz or 115 V / 60H z on the primary side.

Connection to amplifier or receiver

Connect the audio cable to the phono-input of the amplifier or receiver (red or black RCA-type plug = right channel (10), white RCA-type plug = left channel (9).

Connect one side of the ground-wire to the ground socket (11) on the device and the other end to the amplifier.

Balancing the tonearm and setting the tracking and antiskating force –

for example Quintet Red

Remove the needle protector.
Set tracking force (4) to 0 and switch off the antiskating device (5) by turning counter clockwise up to the stop.
Turn the counterweight (3) on to the tonearm.
Balance the tonearm precisely by turning the counterbalance- ce. Thetonearmisbalancedpreciselywhentipivotsfreely.
Set the required tracking force for the cartridge by turning the dial (4).

The tracking force for cartridges Oroton Quintet Red = 23 MN = dial position 2.3.

Set Antiskating to 2.3 as well.

Auflagekraft Auflagekraftskala 4	Antiskating-Installing 9

1 = 10 MN
1,25 12,5 MN
1,5 = 15 MN
2 = 20 MN
2,5 = 25 MN
3 = 30 MN| 1
1,25
1,5
2
2,5
3

Height adjustment oft tonearm

The entire tonearm assembly can be adjusted in height. By loosening the set screw (8) you can move the tone arm in height. Then tighten the set screw again

Manuel start, speed selection 33/45/78, tone arm lift

With the speed selector (7), the corresponding speeds 33 / 45 / 78 can be set. With this button the device is also started.

Remove stylus cover and move lift lever (6) forward.
Now position the tone arm over lead-in groove of the record and push the lift lever back. The tonearm is now lowered slowly, thus preventing damage to your records.
The tone arm can be raisedat a n yposition, also for brief interruptions when playing. For this, slide the lift lever forward. The platter continues to rotate in this case.