moulinex OptiGrill+ GC717810 2000W Grill Instruction Manual
- June 1, 2024
- moulinex
Table of Contents
OptiGrill +
Instructions for use
Please read the “Use & Safety instructions” booklet carefully before first use.
DESCRIPTION
A Control panel
A1 On/off button
A2 Frozen food mode
A3 Cooking programs
A4 4 temperature settings in manual mode; see specific manual mode in
the quick start guide
A5 OK button
A6 Cooking level indicator
B Body
C Handle
D Cooking plates
E Drip tray
F Power cord
COOKING LEVEL INDICATOR
Preheating
- Flashing white coloured light: preheating in progress
- Steady white coloured light and beeping: ready to cook
Cooking
- First cooking level in progress
- First cooking level reached
- Rare level in progress
- Rare level reached
- Medium level in progress
- Medium level reached
- Well-done level in progress
- Well-done level reached
For each automatic program, Optigrill lets you know when your food has reached the desired cooking level. When a cooking level is reached, the grill beeps to notify you.
BEFORE FIRST USE
1 2
3 4
5
1. Remove all packaging materials, stickers and accessories from the
inside and the outside of the appliance.
2. Before using for the first time, thoroughly clean the plates with warm
water and a little dishwashing liquid, rinse and dry thoroughly.
3. Position the removable drip tray at the front of the appliance.
4. Make sure that the upper and lower plates are correctly positioned in
the product. Do not activate preheating without the plates. Connect the
appliance to the mains supply (the cable must be completely unwound).
5. Press the on/off button.
Caution : Make sure there is no food between the plates
GRILL POSITION
A) USING AN AUTOMATIC PROGRAM
6 automatic programs:
red meat, burger, sausage, poultry, fish, sandwiches
1 2
3 4
5
1. If the food you wish to cook is frozen, press the corresponding
button.
This function is only available when cooking with the automatic programs, not
in manual mode.
2. Select the appropriate cooking program according to the type of food
you wish to cook.
Tip, especially for meat: The cooking results on the automatic programs
may vary depending on origin, cut and quality of the food being cooked, the
programs have been set and tested for good quality food.
Similarly, the thickness of the meat must be taken into account during
cooking; you should not cook foods with a thickness greater than 4 cm.
If you are uncertain about which cooking program to use, please refer to the
cooking guide page 11.
3. Press the “ OK ” button: the appliance starts preheating and the
cooking level indicator flashes white.
NB: If you have selected the wrong program, turn off the appliance and
repeat the steps.
4. Wait for preheating to be complete.
5. When the level indicator stops flashing white and the grill beeps, the
preheating is complete, the grill is ready to cook.
Comments: At the end of preheating, if the appliance remains closed, the
safety system will turn off the appliance after a while.
6
7
8
6. Open the grill and place the food on the cooking plate.
Comments: If the appliance remains open for too long, the safety system
will turn off the appliance automatically after a while.
7. Close the appliance to start the cooking cycle. The cooking level
indicator turns blue to indicate the cooking is in progress (for the best
results, do not open or move your food during the cooking process). The
appliance automatically adjusts the cooking cycle (time and temperature)
according to the food thickness and quantity.
Note for very thin pieces of food: Close the appliance, the button OK
will flash and the indicator will stay steady white until you press OK.
Press OK to ensure the appliance recognizes the food and that the cooking
cycle starts.
8. According to the level of cooking, the indicator light changes color.
While cooking is in progress, a beep alerts you each time a cooking level is
reached. When the indicator light is yellow with a beep, food is rare, orange
with a beep, food is medium and red with a beep, food is well done.
N.B.: If you like your meat very rare, remove the meat when the cooking
level indicator reaches steady blue.
Please note, especially on meat, it is normal that cooking results vary
depending on type, quality and origin of food.
9
10
9. When the color corresponding to your desired cooking level becomes
steady and the beep sounds, open the appliance and remove your food.
Note: If you want to cook food to different personal tastes, open the
grill and remove the food when it has reached the desired level and then close
the grill and continue cooking the other food. The program will continue its
cooking cycle until it reaches the final level.
10. When finished cooking, remove food and close the appliance. The
control panel will light up and set itself to ‘choice of program’ mode.
Comment: The security system will turn off automatically after a while if
no program selection is made
Keep warm function
Once the red level is reached, the cooking is finished, the appliance
automatically activates the keep warm function, the indicator light is red,
and the device begins to beep every 20 seconds. If food is left on the grill,
it will continue to cook while the cooking plates cool. You may deactivate the
beep by pressing the button ” OK “.
Note: The security system will power off the appliance automatically
after a while.
Cooking a second batch straight away:
Once your first batch of food has finished cooking:
a) Make sure that the appliance is closed, and that no food is remaining
inside.
b) Select the cooking program (this step is necessary even if the program
is the same as for the foods you have just finished cooking).
c) Press the button ” OK ” to begin preheating. While preheating, the
color level indicator will flash white.
d) Once preheating is complete, the appliance will beep, and the
indicator light will be steady white.
e) The appliance is ready to be used once preheating is complete. Open
the grill and place the food inside the appliance.
Important:
– Please note that preheating is required for each new batch. Before
preheating, make sure that the appliance is closed, and that no food is
remaining inside. Wait for preheating to finish before opening the grill and
placing food inside.
– If the new preheating cycle is activated immediately after the end of the
previous cycle, the preheating time will be reduced.
B) USING THE MANUAL MODE
1 2
3 4
5 6
1. Select the manual mode and the cooking temperature by clicking on M several times until the colour matches your desired temperature:
| 110-125°C
---|---
| 180-195°C
| 220-235°C
| 255-275°C
2. Press OK to start preheating. The cooking level indicator flashes with
the selected colour: preheating in progress. Wait until preheating is
finished.
3. When the desired temperature is reached, the light stops flashing and
the grill beeps: the grill is ready to cook.
4. Add the food on the grill, the cooking process begins.
5. You can adjust the temperature during cooking.
6. Watch the food cook and remove it when you consider it cooked as
desired.
C) COOKING GUIDE
6 AUTOMATIC COOKING PROGRAMS
|
COOKING LEVEL INDICATOR
---|---
| | | | **
BEEF**|
Very rare (Blue)
| Rare| Medium|
Well-done
BURGER|
–
| Rare| Medium|
Well-done
SAUSAGE|
–
| –| –|
Well-done
CHICKEN|
–
| –| –|
Well-done
FISH|
–
| Medium| Medium well|
Well-done
SANDWICH|
–
| Lightly cooked| Grilled|
Crispy
MANUAL MODE IN GRILL POSITION
| 180-195°C| 220-235°C| 255-275°C
---|---|---|---
POTATOES| **| |
ZUCCHINI / SQUASH| | | **
EGGPLANT| | **|
TOMATOES| | | **
ASPARAGUS| | | **
MUSHROOMS| | | **
ONIONS| | **|
BROCOLI| **| |
BABY CARROTS| **| |
FENNEL| | **|
SWEET POTATOES| **| |
APPLE SLICES| | **|
PINEAPPLE| | **|
PEACH| | **|
PORC| | |
SEAFOOD| **| |
PEPPER| | **|
END OF USE
1 2
3
1. Turn off the appliance by pressing the on/off button on the handle.
2. Unplug the appliance from outlet.
3. Allow to cool for at least 2 hours. To avoid accidental burns, allow
grill to cool thoroughly before cleaning.
CLEANING
1 2
3
4
5 6
1. Before cleaning, unlock and remove the plates and drip tray to prevent
damage to the cooking surface.
Drain the drip tray and wash it in mild soapy water, then dry thoroughly with
a paper towel.
2. Do not immerse the body of grill in water or any other liquid.
3. The appliance and its cord cannot be placed in the dishwasher. The
heating elements, visible and accessible parts, should not be cleaned after
removing the plates. If they are very dirty, wait until the appliance has
completely cooled down and clean them with a dry cloth.
4. If you do not wish to wash the cooking plates and drip tray in the
dishwasher, use hot water and a little washing up liquid to clean, then rinse
thoroughly to remove any residue. Wipe them carefully with a paper towel.
Do not use metal scouring pads, steel wool or abrasive cleaners to clean any
part of the grill, use only nylon or non-metallic cleaning pads.
5. To clean the grill cover, wipe with a warm, wet sponge and dry with a
soft, dry cloth.
6. Always make sure the grill is clean and dry before storing.
Any repairs must be carried out by an approved service representative.
Troubleshooting guide
| Problem | Cause | Solution |
|---|
Button blinking
+ Indicator light solid blue
+ Button blinking|
- Switching the appliance or starting an automatic cooking cycle with food and without plates preheating (manual mode is automatically activated).
|
- 2 possible options:
– Choose the temperature setting by pressing the button and then press OK. Allow to cook, but you must monitor the cooking (manual mode).
– stop the appliance, remove the food, close the appliance properly, re- program the appliance and wait until end of preheating.
The appliance stops during the cycle of pre-heating or cooking.|
- The appliance has been kept open for too long while cooking.
- The appliance has been idle too long after the end of warm up or keep warm.
|
- Disconnect the appliance from the outlet and leave for 2-3 mins., restart the process. The next time you use the appliance, make sure you open and close it quick for best cooking results. If the problem occurs again contact your local customer service.
The indicator light will blink purple
+ Button / / blinking
+ Intermittent beeping|
- Appliance failure.
- Appliance stored or used in a room that is too cold.
|
- Disconnect and reconnect your appliance and immediately restart a preheat cycle. If the problem persists, contact your Customer Service.
The device does not beep.
The indicator light will blink purple
+ Button blinking
+ Continuous beeping|
- Appliance failure.
|
- Unplug the appliance and contact customer service.
After preheating, I placed the food inside and closed the appliance, but the indicator light stays white and cooking does not begin.|
- The quantity of food inside the appliance is greater than 4 cm.
|
-
The quantity of food should not exceed 4 cm.
-
The grill was not opened completely when placing the food inside.
|
-
Open the grill completely and close it again.
-
The appliance does not detect food inside The quantity of food is insufficient, ” OK ” is blinking.
|
- Confirm cooking activation by pressing the button .
The appliance will activate in manual mode
+ The indicator light will blink red.
+ button temp control and light fixed|
- Preheating time was cut short.
|
-
Monitor the cooking periodically (for use in manual mode).
Or -
Stop the grill, remove food, close the grill, select the new cooking programme you wish to use and wait for the preheating cycle to finish.
2100132520