moulinex 2100130487 OptiGrill 4 in 1 XL Intelligent Combo Grill Instruction Manual

moulinex 2100130487 OptiGrill 4 in 1 XL Intelligent Combo Grill

Please read the “Use & Safety instructions” booklet carefully before first use.

PRODUCT DESCRIPTION

• A. Control panel
• A1. On/Off button
• A2. Frozen food function
• A3. 12 automatic cooking programs
• A4. Manual mode with 4 temperatures
• A5. Confirm the selection and start preheating
• A6. Cooking level indicator
• B. Release the latch for barbecue and complete meal positions
• C. Side thermostat for barbecue and complete meal positions
• D. Indicator light for barbecue and complete meal positions
• E. Front drip tray
• F. Back drip tray
• G. Baking tray
• H. Bottom plate
• I. Top plate
• J. Power cord

POSITIONS AND INTERFACE

CHANGE POSITION

Change to oven position

Open the grill, remove the lower grill plate and replace with the baking tray.
Caution: The baking tray is placed on the grill without being locked into place.

Change to barbecue position
When opening the grill, hold the latch up and bring the handle to the 180° open barbecue position.

Change to complete meal position
Plug the baking tray in place of the lower plate, then open the grill to the 180° position following the steps above.
Caution: Check that the thermostat on the side is on before opening the grill in the barbecue or complete meal position. If the thermostat is not on the grill will start heating up and will notify you of this with a beep.

COOKING LEVEL INDICATOR
For each automatic program, Optigrill lets you know when your food has reached the desired cooking level. When a cooking level is reached, the grill beeps to notify you.

BEFORE FIRST USE

1. Remove all packaging materials, stickers and accessories from the inside and the outside of the appliance.
2. Additional colour ring stickers are provided.
3. You can stick your preferred language on the original colour ring.
4. Before using it for the first time, thoroughly clean the plates with warm water and a little dishwashing liquid, rinse and dry thoroughly.
5. Position the removable drip trays at the front and the back of the appliance.
6. Make sure that the upper and lower plates are correctly positioned in the product. Do not activate preheating without the plates.
7. Connect the appliance to the mains supply (the cable must be completely unwound).
8. Press the on/off button.
   Caution: Make sure there is no food between the plates.

USING AN AUTOMATIC PROGRAM

12 automatic programs
red meat, burger, sausage, pork, chicken, fish, seafood, sandwich, pepper, eggplant, potatoes, veggie steak

1. If the food you wish to cook is frozen, press the corresponding button.

2. This function is only available when cooking with the automatic programs, not in manual mode.

3. Select the appropriate cooking program according to the type of food you wish to cook.

4. Tip, especially for meat: The cooking results on the automatic programs may vary depending on the origin, cut and quality of the food being cooked, the programs have been set and tested for good quality food.

5. Similarly, the thickness of the meat must be taken into account during cooking; you should not cook foods with a thickness greater than 4 cm.

6. If you are uncertain about which cooking program to use, please refer to the cooking guide on page 13.

7. Press the “OK” button: the appliance starts preheating and the cooking level indicator flashes white.
   NB: If you have selected the wrong program, turn off the appliance and repeat the steps.

8. Wait for the preheating to be complete.

9. When the level indicator stops flashing white and the grill beeps, the preheating is complete, and the grill is ready to cook. Comments: At the end of preheating, if the appliance remains closed, the safety of the system will turn off the appliance after a while.

10. Open the grill and place the food on the cooking plate.
    Comments: If the appliance remains open for too long, the safety system will turn off the appliance automatically after a while.

11. Close the appliance to start the cooking cycle. The cooking level indicator turns blue to indicate the cooking is in progress (for the best results, do not open or move your food during the cooking process). The appliance automatically adjusts the cooking cycle (time and temperature) according to the food thickness and quantity. Note for very thin pieces of food: Close the appliance, the button OK will flash and the indicator will stay steady white until you press OK. Press OK to ensure the appliance recognizes the food and that the cooking cycle starts.

12. According to the level of cooking, the indicator light changes colour. While cooking is in progress, a beep alerts you each time a cooking level is reached. When the indicator light is yellow with a beep, food is rare, orange with a beep, food is medium and red with a beep, food is well done.
    N.B.: If you like your meat very rare, remove the meat when the cooking level indicator reaches steady blue. Please note, especially on meat, it is normal that cooking results vary depending on type, quality and origin of food.

13. When the colour corresponds to your desired cooking level becomes steady and the beep sounds, open the appliance and remove your food.
    Note: If you want to cook food to different personal tastes, open the grill and remove the food when it has reached the desired level and then close the grill and continue cooking the other food. The program will continue its cooking cycle until it reaches the final level.

14. When finished cooking, remove the food and close the appliance. The control panel will light up and set itself to ‘choice of the program m’ mode.
    Comment: The security system will turn off automatically after a while if no program selection is made.

Keep warm function

Once the red level is reached, the cooking is finished, the appliance automatically activates the keep warm function, the indicator light is red, and the device begins to beep every 20 seconds. If food is left on the grill, it will continue to cook while the cooking plates cool. You may deactivate the beep by pressing the button ” OK
Note: The security system will power off the appliance automatically after a while.

Cooking a second batch straight away
Once your first batch of food has finished cooking:

• Make sure that the appliance is closed, and that no food is remaining inside.
• Select the cooking program (this step is necessary even if the program is the same as for the foods you have just finished cooking).
• Press the button OK to begin preheating. While preheating, the colour level indicator will flash white.
• Once preheating is complete, the appliance will beep, and the indicator light will be steady white
• The appliance is ready to be used once preheating is complete. Open the grill and place the food inside the appliance.

Important

• Please note that preheating is required for each new batch. Before preheating, make sure that the appliance is closed, and that no food is remaining inside. Wait for preheating to finish before opening the grill and placing food inside.
• If the new preheating cycle is activated immediately after the end of the previous cycle, the preheating time will be reduced.

GRILL POSITION

USING THE MANUAL MODE

1. Select the manual mode and the cooking  temperature by clicking on M several times until the colour matches your desired temperature
2. Press OK to start preheating. The cooking level indicator flashes with the selected colour: preheating in progress. Wait until preheating is finished.
3. When the desired temperature is reached, the light stops flashing and the grill beeps: the grill is ready to cook.
4. Add the food to the grill, and the cooking process begins.
5. You can adjust the temperature during cooking.
6. Watch the food cook and remove it when you consider it cooked as desired.

COOKING GUIDE

12 AUTOMATIC COOKING PROGRAMS

MANUAL MODE IN GRILL POSITION

OVEN POSITION

1. If your OptiGrill is already on and you want to use the baking tray, unplug the grill and let it cool down for at least 2 hours.

2. Put the ingredients in the baking tray.

3. Open the grill, remove the lower grill plate and replace it with your baking tray.
   CAUTION: Be careful that the upper grill plate is correctly installed in the appliance.

4. Close the grill and press the On/Off button.

5. Select the manual mode and the cooking temperature by clicking on M several times until the colour matches your desired temperature:

6. Begin preheating by pressing the OK button.

7. When the desired temperature is reached, the grill will beep, and the cooking process will begin.

8. You can adjust the temperature during the cooking process.

9. Watch the food cook. When you consider it cooked as desired, end the cooking by pressing the ON/OFF button. All buttons switch off, the grill stops heating/cooking.

10. Open the grill and remove the baking tray from the grill using its handles.
    CAUTION: On hot surfaces, the use of gloves is recommended. If the baking tray is hot, make sure to place it on an adapted surface.

11. The baking tray can go in the dishwasher.

BARBECUE POSITION

1. Open the grill in the barbecue position. The cooking is managed with the side thermostat.
2. Select the desired temperature setting.
3. The thermostat sets the same cooking temperature for both plates:
4. The side light indicator flashes red during preheating.
5. When the light indicator becomes steady red and the grill beeps, the grill is ready to use.
6. Add food on the grill.
7. Watch the food cook and remove it once it is done.
8. Turn off the appliance by setting the thermostat to
9. Comments:
   • You can change the temperature during cooking. If it is changed during cooking, the grill will adjust the temperature to the new setting.
   • If you cook food on one plate only, use the top one.

COMPLETE MEAL POSITION

1. Put the grill in a complete meal position. The cooking is managed with the side thermostat.

2. Select the desired temperature setting. The thermostat controls the cooking temperature for both plates.

3. The side light indicator flashes red during preheating.

4. When the light indicator becomes steady red and the grill beeps, the grill is ready to use.

5. Add food on the grill and in the baking tray.

6. Watch the food cook and remove it once it is done.

7. Turn off the appliance by setting the thermostat.
   Comment

   • You can change the temperature during cooking. If it is changed during cooking, the grill will adjust the temperature to the new setting.
     Tips
     If your side dish takes longer to cook than what you’re grilling, you can also start cooking in an oven position.

8. If you are doing this, please refer to page 14 and follow steps 1 to 7. When the food is cooked as desired, open your grill in a barbecue position. The grill automatically switches to the thermostat on the side.
   Choose the desired temperature setting using the thermostat. When the grill plate has preheated, put the food on it.

END OF USE

1. Turn off the appliance by pressing the on/off button on the handle in the grill/oven positions.
   • Set the side thermostat to in barbecue/ complete meal positions.
2. Unplug the appliance from the outlet.
3. Allow to cool for at least 2 hours.
4. To avoid accidental burns, allow the grill to cool thoroughly before cleaning.

CLEANING

1. Before cleaning, unlock and remove the plates, drip trays, and baking trays to prevent damage to the cooking surface. Drain the juice drip trays and wash them in mild soapy water, then dry thoroughly with
   a paper towel.

2. Do not immerse the body of the grill in water or any other liquid.

3. The appliance and its cord cannot be placed in the dishwasher. The heating elements, visible and accessible parts, should not be cleaned after removing the plates. If they are very dirty, wait until the appliance has completely cooled down and clean them with a dry cloth.

4. If you do not wish to wash the cooking plates, drip trays, and baking trays in the dishwasher, use hot water and a little washing-up liquid to clean, then rinse thoroughly to remove any residue. Wipe them carefully with a paper towel. Do not use metal scouring pads, steel wool or abrasive cleaners to clean any part of the grill, use only nylon or non-metallic cleaning pads.

5. To clean the grill cover, wipe with a warm, wet sponge and dry with a soft, dry cloth.

6. Always make sure the grill is clean and dry before storing. Any repairs must be carried out by an approved service representative.

Troubleshooting guide

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>