BOSCH GAL 18V-160 Professional Starter Kit Instruction Manual

: June 1, 2024
: Bosch

Table of Contents

Safety instructions
Product description and specifications
Technical Data
Charging process
Troubleshooting
Maintenance and Service
Disposal
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

BOSCH GAL 18V-160 Professional Starter Kit Instruction Manual

Safety instructions

Installation Instruction

Read all the safety and general instructions. Failure to observe the safety and general instructions may result in electric shock, fire and/or serious injury.

Store these instructions in a safe place.
Only use the charger if you can fully evaluate all functions and carry them out without restrictions, or if you have received corresponding instructions.

This charger is not intended for use by children or persons with physical, sensory or mental limitations or a lack of experience or knowledge. This charger can be used by children aged 8 or older and by persons who have physical, sensory or mental limitations or a lack ofexperience or knowledge if a person responsible for their safety supervises them or has instructed them in the safe operation of the charger and they understand the associated dangers. Otherwise, there is a risk of operating errors and injuries.
Supervise children during use, cleaning and maintenance. This will ensure that children do not play with the charger.
Only charge Bosch Li-ion batteries or batteries of AMPShare partners with a capacity of 1.3 Ah or more. The battery voltage must match the battery charging voltage of the charger. Do not charge any non-rechargeable batteries. Otherwise there is a risk of fire and explosion.
Only use the charger in enclosed spaces and do not expose it to wet conditions. Water entering a charger increases the risk of electric shock.
Keep the charger clean. Dirt poses a risk of electric shock.
Always check the charge, including the cable and plug, before use. Stop using the charger if you discover any damage. Do not open the charger yourself, and have it repaired only by Bosch or by an authorised after-sales service centre using only original replacement parts. Damaged chargers, cables and plugs increase the risk of electric shock.
Do not operate the charger on an easily ignited surface (e.g. paper, textiles, etc.) or in a flammable environment. There is a risk of fire due to the charger heating up during operation.
Do not cover the ventilation slots of the charger. Otherwise, the charger may overheat and no long function properly.
Recharge only with the charger specified by the manufacturer. A charger that is suitable for one type of batterypack may create a risk of fire when used with another battery pack.
In case of damage and improper use of the battery, vapours may also be emitted. Ensure the area is well ventilated and seek medical attention should you experience any adverse effects. The vapours may irritate the respiratory system.
Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical help. Liquid ejected from the battery may cause irritation or burns

Products sold in GB only:
Your product is fitted with an BS 1363/A approved electric plug with internal fuse (ASTA approved to BS 1362). If the plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place by an authorised customer service agent. The replacement plug should have
the same fuse rating as the original plug. The severed plug must be disposed of to avoid a possible shock hazard and should never be inserted into a mains socket elsewhere.

Product description and specifications

Intended use
The battery charger is intended for charging rechargeable Bosch Li-Ion batteries or those of the AMPShare partners.

Product Features
The numbering of the product features refers to the representation of the charger in the images.

Charging bay
Green battery charge indicator
MODE button
Red temperature monitoring/error indicator
Wall mount

Technical Data

Battery Charger	GAL 18V-160
Protection class	/ II
Charging currentA)	16 A
Battery charging voltage (automatic voltage detection)	14.4–18 V

A) Depends on temperature and rechargeable battery type Values can vary depending upon the product and are subject to application and environmental conditions. For further information www.bosch-professional.com/wac.

Charging process

Pay attention to the mains voltage. The voltage of the power source must match the voltage specified on the rating plate of the charger.
The charging process begins as soon as the mains plug for the charger is inserted into the mains socket and the battery is inserted into the charging bay ( 1).

The charging process is only possible when the temperature of the battery is within the permitted charging temperature range (0–45 °C).
For more information, you can access the onlineoperating instructions atwww .bosch-pt.com/manuals

Charging process
For charging the rechargeable batteries, you can choosebetween 3 different charging modes. Press on the MODE button (3) to switch between the following charging modes:

Standard charging mode
Power Boost charging mode
Service life charging mode

For more information, you can access the onlineoperating instructions atwww .bosch-pt.com/manuals

Wall mounting
Pull the plug out of the socket before carrying out any work on the charger.
The charger can be used either free-standing (for use on a desktop) or mounted on the wall.
When affixing to the wall: Drill 2 holes, leaving a clearance of 86 mm. To secure it, use round-head screws with a diameter of 5 mm to max. 6.5 mm.

Troubleshooting

Battery is not being charged
Battery is not being charged and the red temperature monitoring/error indicator (4) is flashing red.
Cause: The charger has identified an internal error.
Corrective measure: Ensure that all batteries are fully inserted. Remove the mains plug and reinsert. If the error occurs again, have the charger checked by an authorised after-sales service centre for Bosch power tools

Indicators do not light up
None of the indicators are lighting up, battery will not be charged.
Cause: Plug socket, mains cable or battery charger defective
Corrective measure: Check the mains voltage. If necessary, have the charger checked by an authorised after-sales service centre.

Maintenance and Service

Maintenance and Cleaning
In order to avoid safety hazards, if the power supply cord needs to be replaced, this must be done by Bosch or by an after-sales service centre that is authorised to repair Bosch power tools.

After-Sales Service and Application Service Our after-sales service responds to your questions concerning maintenance and repair of your product as well as spare parts. You can find explosion drawings and information on spare parts at: www.bosch-pt.com
The Bosch product use advice team will be happy to help you with any questions about our products and their accessories.
In all correspondence and spare parts orders, please always include the 10‑digit article number given on the nameplate of the product.

Great Britain
Robert Bosch Ltd. (B.S.C.) P.O. Box 98 Broadwater Park North Orbital Road Denham Uxbridge UB 9 5HJ
At www.bosch-pt.co.uk you can order spare parts or arrange the collection of a product in need of servicing or repair.
Tel. Service: (0344) 7360109
E-Mail: boschservicecentre@bosch.com

You can find further service addresses at:
www.bosch-pt.com/serviceaddresses

Disposal

Chargers, accessories and packaging should be recycled in an environmentally friendly manner.
Do not dispose of chargers along with household waste.

Only for EU countries:
According to the European Directive 2012/19/EU on Waste Electrical and Electronic Equipment and its implementation into national law, chargers that are no longer usable must be collected separately and disposed of in an environmentally friendly manner.
If disposed incorrectly, waste electrical and electronic equipment may have harmful effects on the environment and human health, due to the potential presence of hazardous substances.
Only for United Kingdom:
According to The Waste Electrical and Electronic Equipment Regulations 2013 (SI 2013/3113) (as amended), products that are no longer usable must be collected separately and disposed of in an environmentally friendly manner.

**operating instructions

** Scan for more information

QR Code
Company Logo