BOSCH SPI6YMS14E Dishwasher User Guide
- June 1, 2024
- Bosch
Table of Contents
BOSCH SPI6YMS14E Dishwasher
Product Specifications
- Model: Main de splat vase
- Connectivity: Home Connect
- Water Hardness Settings: Low, Medium, High
Product Usage Instructions
Initial Setup
- Connect your device to a mobile terminal. Use the Home Connect app for convenient settings.
- Install the Home Connect app on your mobile device and follow the app instructions.
- Scan the QR code using the Home Connect app.
- Filling the Reservoir
– For salt storage, fill the reservoir with water completely.
Adding Rinse Aid
1. Press the flap of the rinse aid reservoir and lift it.
Adding Detergent
1. Press the detergent dispenser.
Setting Values
- Press the desired setting.
- To access basic settings, press and hold for about 3 seconds.
- To save settings, press and hold for 3 seconds.
Cleaning Instructions
- Check spray arms for rotation freedom.
- Add detergent and start the appliance.
- Set the program and start it.
- Remove dishes after the program completes.
Cleaning Filters
- After each use, check for food residues on filters.
- Remove the filter system and clean it under running water.
Cleaning Spray Arms
- Unscrew the upper spray arms for cleaning.
Cleaning Drain Pump
- Disconnect the appliance from the power source.
- Remove the filter system and drain any remaining water.
- Detach the pump cover using a spoon.
FAQs
Issue: E:61-02 Error Code
- Cause: Drain pump blockage.
- Resolution: Clean the drain pump.
Issue: Water Overflow
- Cause: Incorrectly attached drain pump cover.
- Resolution: Reattach the pump cover securely.
What should I do if the program is not starting?
Ensure that the appliance is properly plugged in and the door is closed. Check if the filters and spray arms are clean and correctly assembled.
How do I add rinse aid to the dishwasher?
Press the lid of the rinse aid compartment and lift it up. Fill the reservoir up to the maximum mark and securely lock the lid.
What are the recommended settings for water hardness?
Refer to the table under ‘General Presentation of Water Hardness Settings’ and adjust according to the hardness of your water supply.
“`