ORIENTOOLS 2400L-H Drill Power Water Pump Instruction Manual
- June 1, 2024
- ORIENTOOLS
Table of Contents
ORIENTOOLS 2400L-H Drill Power Water Pump Instruction Manual
HAND DRILL WATER PUMP
OPERATION
Water needs to be diverted before the pump can be used.
There are in (water inlet) and out (water outlet) on the water pump.
Connect the two ends of the pump with a hose, put the water inlet pipe into
the pumped liquid, lock the pump shaft with the electric drill, make the “in”
end of the water pump (water inlet) as close as possible to the surface of the
pumped liquid (about 10 cm from the height of the pumped liquid), start the
electric drill to pump water. If there is a large amount of liquid spray out
at the water outlet, water diversion is completed, then can start normal
pumping.
NOTE
- Use an electric drill with power greater than 350w and rotating speed higher than 2000 rpm. Insufficient power or low rotating speed will lead to insufficient pumping force. At the same time, insufficient power of the electric drill may also cause the electric drill to work overload and damage the electric drill.
- It is recommended that the water inlet pipe should not be longer than 1m when in use, and the water outlet of the pump should not be more than 50cm from the surface of the pumped liquid after successful water diversion, otherwise it may lead to insufficient pumping force and failure to pump
- If no water is pumped out for 20 seconds during use, please stop pumping immediately (long dry pumping will cause high temperature of water pump and damage of internal parts).
- The electric drill water pump is only for temporary pumping and cannot work continuously for more than 10 minutes. Long-term continuous pumping is likely to cause damage to the internal parts of the pump, and may also damage the electric drill. If you need to pump continuously for a long time, please purchase a professional pump.
- The electric drill water pump cannot pump corrosive liquid, because corrosive liquid will damage the internal parts.
WARRANTY STATEMENT
If you encounter any problem when using the product, please contact us to solve it by corresponding channel.
We warrants to the original purchaser only, that all consumer will be free from defects in material or workmanship during personal use for a period of one (1) years from date of purchase. Ninety days for all products if the tool is used for professional or commercial use. Purchaser has 30 days from the date of purchase to report missing or damaged parts.
Upon the confirmation of an our representative, your product may qualify for
repairs and service work.
When returning a product for warranty service, the shipping charges must be
prepaid by the purchaser.
The product must be shipped in its original container (or an equivalent),
properly packed to withstand the hazards of shipment. The product must be
fully insured with a copy of the proof of purchase enclosed. There must also
be a description of the will be returned and shipped back to the purchaser at
no charge for addresses.