GMC 2007-2013 Sierra 1500 Tail Light User Manual
- June 1, 2024
- GMC
Table of Contents
GMC 2007-2013 Sierra 1500 Tail Light
Installation Informaion
- Unplug the tail light connector at the junction box under the truck.
- Pull all the clips out by removal tool.
- Locate two screws held the tail light.
- Take out the screw by Phillips Head Screwdriver.
- Grab the light and pull it out.
- Identify the light components:
- Braking / Running / Turn Signal Light
- Side Marker Light
- Reverse Light
- Twist out all the sockets and pull out the bulbs.
- Pull out the tail lamp wiring harness.
- Install all original bulbs in the new light wire, twist the sockets back on the light.
- Drop the connector down the hole.
- Line up the installation pins and install new light on.
- Reinstall the two screws.
- Sort out the harness and hold it by the clips.
- Plug the tail light connector at the junction box.
FAQ
- What models are compatible with this tail light assembly?
- 2007-2013 GMC Sierra 1500, 2007-2010 GMC Sierra 2500 HD, and 2007-2010 GMC Sierra 3500 HD.
- What tools are necessary for the installation?
- The specific tools needed are not listed in the images provided. Typically, a Phillips Head Screwdriver and a removal tool for the clips would be required.
- Are the original bulbs reused in the new tail light assembly?
- Yes, the original bulbs are to be installed in the new light wire and secured by twisting the sockets back on the light.
- How is the new tail light secured to the vehicle?
- The new tail light is lined up with the installation pins and then secured by reinstalling the two screws.
TOOLS NEEDED
Installation Instructions
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>