MISENO MV-6022D-BRANT Brantley 60 Free Standing Instruction Manual
- June 1, 2024
- Miseno
Table of Contents
MV-6022D-BRANT Brantley 60 Free Standing
Instruction Manual
MV-6022D-BRANT Brantley 60 Free Standing
PARTS LIST
INCLUDED NO TOOLS REQUIRED
HOW TO KEEP YOUR FURNITURE LOOKING BEAUTIFUL
Quality wood furniture is a significant nvestment expected to last for
generations. To maintain its beauty and help it ast, wood furniture needs the
right care.
To protect and care for your furniture, we suggest the following:
- Clean up spills immediately. Use a blotting rather than a wiping action.
Water eft over a long period of time will cause white spots in the finish. Alcohol, perfume, after-shave and medications can cause severe finish damage.
CLEANING AND POLISHING YOUR FURNITURE
We recommend dusting frequently with a clean, soft, dry, lint-free cloth.
Clean the surface by rubbing in the direction of the grain. We recommend
polishing your furniture approximately every six months, using a clean, soft,
lint-free cloth and rubbing the polish in the direction of the grain.
WHAT FURNITURE CARE PRODUCTS DO WE RECOMMEND?
We recommend polishes which contain detergents, emulsifiers and mineral oil.
The detergents clean dirt from the furniture, the emulsifiers give t body to
clean and last onger and the mineral oil is eft behind as a barrier for dirt
and moisture that could harm finishes. There’s no grit to harm the finish, no
wax to build up and no silicone to raise the sheen and act as a barrier for
touch-up and refinishing.
SINK CARE AND MAINTENANCE
Clean the surfaces with mild soap and warm water. Then dry with a soft cloth.
Clean up spills immediately. Do not use products that contain lemon, vinegar
or other acids. Using this type of cleaning process will cause the finish to
dull.
CLEANING GLASS MIRRORS
Ammonia or vinegar based cleaners can damage mirrors. We recommend a solution
of 50% water and 50% sopropyl alcohol for mirror cleaning.
WARRANTY REGISTRATION
To receive warranty coverage for your purchase, you must complete the
warranty registration form found on our website within 30 days of purchase, or
provide valid proof of purchase detailing the date and ocation of your
purchase.
LIMITED WARRANTY
We warrant our products to be free from defects in material or workmanship
for a period of 1 year from the date of delivery. These warranties are made to
the original purchaser and are limited to the repair or exchange of any parts
which prove defective under normal use during the warranty period.
These warranties do not apply where products have been improperly stored or
improperly installed, misused, abused, or modified n any way. They do not
cover the osts of removing warranted material or the nstallation of
replacement material.
VANITY TOP INSTALLATION
CAUTION
PRODUCT IS FRAGILE. Handle with care to avoid breakage and possible injury.
IMPORTANT NSTRUCTIONS
Read before you begin
- Vanity tops should be nstalled only by experienced installers.
- Two or more people are recommended for this nstallation
- Observe all ocal plumbing and building codes.
- Prior to installation, unpack the new vanity top and inspect for damage. Return the lavatory to its protective carton until you are ready to install it.
- Views n these illustrations are for general representation and may not necessarily define the exact contours of the product.
- If replacing an existing sink, be certain to shut off water supply before removing old sink.
- The walls and floors must be square, plumb and level.
TOOLS AND MATERIALS REQUIRED
A Cloth
B Carpenter’s Level
C Silicone Latex Caulk
D Wooden Shims (Wooden Strips)
-
Make sure the top fits onto the vanity by doing a trial fit (Figure 1). The top should sit flush and level against the vanity. If the top rocks, then wooden shims will be needed to secure a firm fit.
-
Install the faucet and the drain assembly (not provided) onto the top according to drain manufacturer’s nstructions.
Note: DO NOT OVERTIGHTEN -
Apply silicone latex caulk onto the entire edge of the vanity (Figure 2). Set top in place.
-
Trim wood shims if necessary. Wipe off any excess silicone latex caulk with a damp cloth and allow to dry (Figure 3). Try not to move or slide the top in any way for at east 24 hours.
OPTIONAL
Backsplash and Sidesplash Installation (optional):
Apply silicone latex caulk to the back and bottom of the
backsplash/sidesplash. Carefully set the backsplash/sidesplash into place and
push firmly against the wall. Wipe off any excess silicone latex caulk with a
damp cloth (Figure 4).
CARE AND MAINTENANCE
Vanity tops are a significant investment expected to last for generations. To
maintain the beauty and longevity of your nvestment, vanity tops need the
right care.
Cleaning and polishing your vanity top:
We recommend dusting frequently with a clean, soft, damp rag. Use a stone
soap or mild liquid detergent and warm water.
Note: for all other cleaners, follow the nstructions on the container.
The cleaner should be used at least once a week and more frequently with
heavier or usual use. Avoid abrasive cleaners or rough cleaning pads. Do not
use products that contain emon, vinegar or other acids. Using this type of
cleaning process will cause the finish to dull.
Liquid spills such as alcohol, medications, etc. should be cleaned up
promptly. Some iquids with high-acid content can etch your vanity top if left
for any length of time. Popular products that should be promptly cleaned up
are shaving cream, toothpaste, perfume, cologne, nail polish remover, hair
coloring or perm products, shampoo, drain and toilet bowl cleaners.
Place protective pads on the bottom of any heavy objects such as pottery,
appliances or other objects that may scratch the surface. o not stand or place
extremely heavy tems on the vanity top.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>