MISENO MV TAH260 Tahoe 60 Free Standing Instruction Manual

June 14, 2024
Miseno

INSTALLATION MANUAL Measures: inch [millimeter]

DIMENSIONS

PART LIST

PART # DESCRIPTION QUANTITY
A Countertop 1
B Backsplash 1
C Basin 1
D Tilt-down drawer 1
E Adjustable shelf 1
F Door (left) 1
G Door (right) 1
H Top drawer 2
I Drawer dividers set 2
J Drawer 1
K Double depth drawer 1
L Pull-out tray 1
M Handle 8
N Drawer glides 4
O Drawer glides 1
P Butterfly hinge 1
Q Power socket 1
R Hinge 6
S Shelf holder 4
T Metal ring 1
U Metal tube 1

TOOLS REQUIRED

(not supplied)

GFCI ACCESIBILITY GUIDELINE

1.1. Prior to vanity installation, ensure that the wall outlet is in an unobstructed easily accessible area at the rear of the vanity in order to have the GFCI (plug with reset button) accessible.
1.2-1.3. If you have a back panel, it is permissible to enlarge or make a cut- out in the vanity back panel in order to access a wall outlet.
Also, it is recommended to have a certified electrician install a wall outlet in the indicated area if required for accessibility. GFCI FIRST TIME USAGE GUIDELINES
A. This GFCI is shipped from the factory in the tripped condition and cannot be reset until power is supplied to the device. Plug the GFCI to your receptacle.
Ensure that the GFCI is still in the tripped condition by pressing the TEST button.
B. Press the RESET button fully and release. The Status Indicator turns Red. If the Status Indicator turns Off and the GFCI cannot be reset, press the TEST button to trip the GFCI. Contact your electrician as the Line and Load connections in your receptacle might be reversed.
IMPORTANT: Press the TEST button (then RESET button) every month to assure proper operation. If the Status Indicator continuously blinks , or the GFCI cannot be reset / tripped, it must be replaced.

INSTALLATION

DRAWER REMOVE INSTALL DRAWER REMOVE
INSTALL SHELF REMOVE INSTALL

MAINTENANCE AND CARE

Stone countertops (Granite, Marble, etc.) are surprisingly resilient to stains and scratches. However, as a preventative measure, any spills on the stone surfaces should be wiped up within a reasonable amount of time. Don’t let liquid sit on the stone overnight. Stones are most prone to staining by oil and acid, so be sure to blot these spills up as soon as they happen. Follow up by cleaning the stone with a mild non-abrasive soap and water.
In bathrooms specifically, stone tends to attract soap scum, just like man- made tile. Rinse vanity top with clean, hot water frequently.
The use of sealers is also a powerful preventative measure. Your stone was sealed at the factory, but reapplication is necessary over time. How often is determined by the quality of the sealer used, and the frequency of use. We recommend using a penetrating non-toxic sealer for bath areas, but a food-safe sealer is typically not necessary.
If stains and scratches do occur, there are many things you can do as a consumer to remove them. Remove oil based stains with acetone, mineral spirits, or ammonia. Organic stains like coffee, tea, or juice can be removed with hydrogen peroxide, mixed with a few drops of ammonia.
Water spots or rings are the most common problem with bath vanities, and are caused by minerals left behind when water evaporates. These can be removed by buffing the spots gently with 00 gauge steel wool. Likewise, small nicks and scratches can often be removed the same way. Larger scratches, chips, and resilient stains may require professional help. Please contact your local stonemason for details.
Remember the following list of DOs and DON’Ts:

  • DO use preventative cleaning measures to keep your stone pristine.
  • DO use sealers, applied according to the product specific directions.
  • DO blot spills quickly, and wash with mild soap and warm water.
  • DON’T use harsh bathroom cleaners or grout cleaners on any natural stone.
  • DON’T worry if you get a significant stain or scratch that your stone investment is ruined. Virtually anything can be fixed with professional help.

FCC STATEMENT
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
WARRANTY NOT VALID IN MEXICO
LIMITED 1 YEAR WARRANTY
This warranty applies to the DISTRIBUTOR vanities installed for commercial and residential use.
The DISTRIBUTOR warrants that, when installed in accordance with the Recognized Plumbing Industry Practice, the vanities are free of manufacturing defects for a period of one (1) year from the date of purchase.
We guarantee your satisfaction with each vanity. Should any vanity not meet your satisfaction due to a visual defect, simply return it to your retailer with the original packaging, PRIOR TO INSTALLATION, for a replacement.
This warranty applies only to the original purchaser and installation site and is not transferable.
INFORMATION ABOUT YOUR WARRANTY COVERAGE
This warranty does not cover damages or failure attributable to:
▶ Vanities installed with obvious visual defects.
▶ Defects or damages to vanities caused by installation that does not comply strictly with the instructions set forth in the DISTRIBUTOR’s installation manual.
▶ Defects or damage to vanities caused by severe accidents (e.g., fire, impacts).
▶ Damage caused by flooding or standing water from leaking pipes, faucets, household appliances, etc; up to and including flooding and any damage caused by acts of God.
FOR WARRANTY SERVICE

  • To make a claim, contact the DISTRIBUTOR no later than 30 days following the date of discovery or detection of defect.
  • Proof of purchase, such as the bill of sale is mandatory when requesting warranty service.
  • The DISTRIBUTOR reserves the right to designate a representative to inspect the vanity for analysis.
  • No unauthorized person, installer, dealer, agent or employee of th DISTRIBUTOR or any representative is entitled to assume any liability on behalf of the DISTRIBUTOR relating to the sale of this product or has the authority to increase or alter the obligations or limitations of this warranty.

THE SOLE REMEDY PROVIDED BY THIS WARRANTY IS THE REPAIR OR REPLACEMENT OF DEFECTIVE PRODUCTS.
THIS WARRANTY DOES NOT COVER THE COST OF REMOVAL OR INSTALLATION OF NEW PRODUCTS. THE WARRANTY WILL BE VOID IF THIS ITEM IS INSTALLED WITH OBVIOUS VISUAL DEFECTS.

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals