MISENO MV-TAH342 Tahoe 42 Free Standing Instruction Manual
- June 14, 2024
- Miseno
Table of Contents
MISENO MV-TAH342 Tahoe 42 Free Standing Instruction Manual
DIMENSIONS
**PART LIST
**
PART # # DE PIÈCE PARTE #| **DESCRIPTION| QUANTITY
QUANTITÉ CANTIDAD**
---|---|---
A| Countertop| 1
B| Backsplash| 1
C| Basin| 1
D| Tilt-down drawer| 1
E| Adjustable shelf| 1
F| Door (left)| 1
G| Door (right)| 1
H| Top drawer| 2
I| Drawer dividers set| 2
J| Drawer| 1
K| Double depth drawer| 1
L| Pull-out tray| 1
M| Handle (long)| 2
N| Drawer glides| 4
O| Drawer glides| 1
P| Butterfly hinge| 1
Q| Power socket| 1
R| Hinge| 6
S| Shelf holder| 4
T| Metal ring| 1
U| Metal tube| 1
V| Handle (short)| 6
TOOLS REQUIRED (not supplied
GFCI ACCESIBILITY GUIDELINE
1.1 Prior to vanity installation, ensure that the wall outlet is in an
unobstructed easily accessible area at the rear of the vanity in order to have
the GFCI (plug with reset button) accessible.
Drawings are for reference only .
1.2-1.3. If you have a back panel, it is permissible to enlarge or make a cut-out in the vanity back panel in order to access a wall outlet. Also, it is recommended to have a certified electrician install a wall outlet in the indicated area if required for accessibility.
GFCI FIRST TIME USAGE GUIDELINES
A. This GFCI is shipped from the factory in the tripped condition and cannot
be reset until power is supplied to the device. Plug the GFCI to your
receptacle. Ensure that the GFCI is still in the tripped condition by pressing
the TEST button. B. Press the RESET button fully and release. The Status
Indicator turns Red. If the Status Indicator turns Off and the GFCI cannot be
reset, press the TEST button to trip the GFCI. Contact your electrician as the
Line and Load connections in your receptacle might be reversed.
IMPORTANT : Press the TEST button (then RESET button) every month to
assure proper operation. If the Status Indicator continuously blinks , or the
GFCI cannot be reset / tripped, it must be replaced.
Receptacle panel
Press the RESET button
**INSTALLATION
REMOVE
**
INSTALL
**DRAWER
REMOVE
INSTALL**
**SHELF
**
**INSTALL
**
Stone countertops (Granite, Marble, etc.) are surprisingly resilient to stains
and scratches. However, as a preventative measure, any spills on the stone
surfaces should be wiped up within a reasonable amount of time. Don’t let
liquid sit on the stone overnight. Stones are most prone to staining by oil
and acid, so be sure to blot these spills up as soon as they happen. Follow up
by cleaning the stone with a mild non-abrasive soap and water. In bathrooms
specifically, stone tends to attract soap scum, just like man-made tile. Rinse
vanity top with clean, hot water frequently. The use of sealers is also a
powerful preventative measure. Your stone was sealed at the factory, but
reapplication is necessary over time. How often is determined by the quality
of the sealer used, and the frequency of use. We recommend using a penetrating
non-toxic sealer for bath areas, but a food-safe sealer is typically not
necessary. If stains and scratches do occur, there are many things you can do
as a consumer to remove them. Remove oil based stains with acetone, mineral
spirits, or ammonia. Organic stains like coffee, tea, or juice can be removed
with hydrogen peroxide, mixed with a few drops of ammonia.
Water spots or rings are the most common problem with bath vanities, and are
caused by minerals left behind when water evaporates. These can be removed by
buffing the spots gently with 00 gauge steel wool. Likewise, small nicks and
scratches can often be removed the same way. Larger scratches, chips, and
resilient stains may require professional help. Please contact your local
stonemason for details. Remember the following list of DOs and DON’Ts:
- DO use preventative cleaning measures to keep your stone pristine.
- DO use sealers, applied according to the product specific directions.
- DO blot spills quickly, and wash with mild soap and warm water.
- DON’T use harsh bathroom cleaners or grout cleaners on any natural stone.
- DON’T worry if you get a significant stain or scratch that your stone investment is ruined. Virtually anything can be fixed with professional help.
FCC STATEMENT
Warning : Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
WARRANTY NOT VALID IN MEXICO
LIMITED 1 YEAR WARRANTY
This warranty applies to the DISTRIBUTOR vanities installed for commercial and
residential use.
The DISTRIBUTOR warrants that, when installed in accordance with the
Recognized Plumbing Industry Practice, the vanities are free of manufacturing
defects for a period of one (1) year from the date of purchase.
We guarantee your satisfaction with each vanity. Should any vanity not meet
your satisfaction due to a visual defect, simply return it to your retailer
with the original packaging, PRIOR TO INSTALLATION, for a replacement. This
warranty applies only to the original purchaser and installation site and is
not transferable.
INFORMATION ABOUT YOUR WARRANTY COVERAGE
This warranty does not cover damages or failure attributable to:
-
Vanities installed with obvious visual defects.
-
Defects or damages to vanities caused by installation that does not comply strictly with the instructions set forth in the DISTRIBUTOR’s installation manual.
Defects or damage to vanities caused by severe accidents (e.g., fire, impacts). -
Damage caused by flooding or standing water from leaking pipes, faucets, household appliances, etc; up to and including flooding and any damage caused by acts of God.
FOR WARRANTY SERVICE
- To make a claim, contact the DISTRIBUTOR no later than 30 days following the date of discovery or detection of defect.
- Proof of purchase, such as the bill of sale is mandatory when requesting warranty service.
- The DISTRIBUTOR reserves the right to designate a representative to inspect the vanity for analysis.
- No unauthorized person, installer, dealer, agent or employee of th DISTRIBUTOR or any representative is entitled to assume any liability on behalf of the DISTRIBUTOR relating to the sale of this product or has the authority to increase or alter the obligations or limitations of this warranty.
THE SOLE REMEDY PROVIDED BY THIS WARRANTY IS THE REPAIR OR REPLACEMENT OF
DEFECTIVE PRODUCTS.
THIS WARRANTY DOES NOT COVER THE COST OF REMOVAL OR INSTALLATION OF NEW
PRODUCTS. THE WARRANTY WILL BE VOID IF THIS ITEM IS INSTALLED WITH OBVIOUS
VISUAL DEFECTS.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>