HNON WK-0303 One Piece Toilet Instruction Manual

One-Piece Toilet
INSTALLATION INSTRUCTIONS

WK-0303

INCLUDED PARTS:

TOILET SEAT INSTALLATION

1. Turn Off Water Supply
   – Close toilet supply valve and flush tank completely, use towel to remove excess water.
   – Disconnect and remove supply line, if you are replacing the valve shut main water supply first.
   – Remove closet bolts from flange and clean wax and putty from base area.

2. Rough-In the Toilet
   – Measure the wall from behind the toilet to the middle of the closet bolt. Your rough-in measurement should be 12″,

3. Install Closet Bolts
   – Install closet bolts to flange channel, turn 90° and slide into place 6″ (152mm) apart and parallel to wall

4. Install Wax Seal
   – Invert toilet on floor (use cushion to prevent damage), and install wax ring evenly around waste flange with tapered end of ring facing toilet. Apply a thin bead of sealant around toilet base.

5. Position Toilet on Flange
   – Hand-tighten water supply hose to the fill valve in the back of the toilet. Do not connect to water supply yet.
   – Unplug floor waste opening and install toilet on closet flange so bolts project through the mounting holes.
   – Loosely install retainer washers and nuts

6. Install Toilet
   + Position toilet square to wall and, with a rocking motion, press bowl down fully on wax ring and flange.
   Alternately tighten nuts until toilet is firmly sealed to floor. Do not over- tighten nuts, it might crack ceramic
   – Smooth off the bead of sealant around the base.
   Remove excess sealant.
   – Place cover caps to hide installation holes on toilet.
   – Connect water supply to shut off valve, and check for leaks. Tighten if necessary.

1. Dissassemble
   – Disassemble the cover cap and the hinge.

2. Construct Hinges
   – Insert screw and nut into the hole on the hinge.
   – Attach blind hole screw fixing to the bottom of screw.

3. Attach Hinges
   – Insert hinges with blind hole screw fixings attached into holes on toilet bowl.
   – Lightly tighten hinges with a screwdriver too allow for later adjustment.

4. Adjust and Cover Hinges
   – Be sure the hinge is all the way forward for proper seat fitting.
   – Place the covers onto the hinges.

5. Adjust and Attach Seat
   – Align seat to the hinges then firmly tighten the hinges.
   – Attach seat to the secure hinges.
   – Adjust seat to align to the bowl.

TOILET SEAT USAGE

– To remove, push middle button until you hear a “click’, then pull straight up.
– To re-install, align hinge posts with reference marks on seat, then push down until your hear a “click”.

www.HNON.com 
business@kerde.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>