SJ WY Wall Whiteboard Large Magnetic Whiteboard Instruction Manual
- June 1, 2024
- SJ WY
Table of Contents
SJ WY Wall Whiteboard Large Magnetic Whiteboard
Components
2x Dry-Erase Board
BEFORE ASSEMBLY
When you unpack and prepare for assembly, please place the contents on a carpeted or padded area to protect them from damage.
BOX CONTENTS
White Board & Fixing Parts
Fixing Parts
- 4 x 35 mm wall screw
A
- 1 x marker tray
B
- 6x30mm anchors
**C
**
- 4.2 x 16 mm wall screw
**D
**
- 1x screwdriver
E
Tools for Required (not included)
power drill (for pilot holes only)
Step 1 : Turn the whiteboard upside down. Then open the whiteboard and keep 2 boards at 180°horizontal.
Step 2: Use Part D install marker tray on the middle side of the whiteboard. (Auxiliary Tool: Part E) Please tighten the screws to ensure that the marker tray is firmly installed.
Step 3: Drill 4 holes in the wall (the diameter of the hole should not exceed 6mm, the drilling distance based on the actual distance of hooks) and insert Part C into the wall tightly. Then screw Part A (leave 3mm length outside the wall) into Part C.
Step 4: Hang the whiteboard on the wall.
TIPS FOR USING THE WHITEBOARD
- Please peel off the protective film from the writing surface before use. For your convenience, we’ve already cut a long the board frame. You just need to use your thumb or a knife to tear the film a little bit form the board corner and then take off the film step by step.
- Please use good quality whiteboard markers(water-based). Oil-based markers and permanent markers are forbidden.
- Clean surface with a dry or damp soft cloth. Do not use abrasive cleaners. Whiteboard cleaner would be more helpful to wipe off.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>