AMD Supply DC307A Emitter Control System Owner’s Manual
- June 1, 2024
- AMD Supply
Table of Contents
Control System Owner’s Manual
DC307A DC313
DC307A Emitter Control System
All controls support 433MHz
All controls support 3V(CR2430)
Specific parameters to the nameplate shall prevail
Technical Support
Input voltage: 3V(CR2430)
Transmitting frequency: 433.92MHz
Operating temperature: — 20°C ~ + 55°C
Transmssion distance: 200 meters open office 35 meters on two walls
Transmitter: You can choose single channel (0¢305(4/G) ) ,five
channels(Oc306(4/G/E) ), Each indicator light means one control channel. Press
“channel choose” button P1-Cindicator move left side) or P1+(indicator move
right side) to change the channel. On the analogy of this, loose finger when
the indicator light move to suitable channel that you select effective
channel. All indicator lights flash that means all channels is effective¢group
control state).
Transmitter: You can choose nine channels (0C307(4/6) ) ,fifteen
channels(0C313(A/G/E) ), One number of LCD screen means one control channel.
Press“channel choose”button P1-(number descending) or P1+(number increasing)
to change the channel.
On the analogy of this,loose finger when the indicator light move to suitable
channel that you select effective channel.
If LCD screen number show o that means all channels if effective¢group control
state).
Notice: transmitter Do not exposed to moisture and strike, so as not to
affect life.
When you use transmitter, if found emission distance obviously short or less
sensitive, please change another same new battery. Please have batteries for
recycling.
Type Specification
DC305G DC306G DC306E DC307G DC313G DC313E and DC305(A) DC306(A) DC307(A) DC313(A) ha v e diff er ent button mark, but the func tion is the same .
Caution:
This device complies with Part 15 of the FCC. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
(2) this device must eccept any interference received. including interference
that may cause undesired operation.
Any changes or mod tions not expressly approved Oe cot responsible for
compliance could void the user’s authorily to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to tadio of television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Rreorent or relocate the fecerving antenna.
- Increase the separation uipment end receiver.
- Connect the equipment into an nutet oh t from that to which the is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>