Heights Telecom HT-360AX Cutting-Edge WiFi 6 AX Router Installation Guide
- June 1, 2024
- Heights Telecom
Table of Contents
HT-360AX Cutting-Edge
WiFi 6 AX Router
Installation Guide HT-360AXG
Quick Installation Guide
HT-360AXG Router
HT-360AX Cutting-Edge WiFi 6 AX Router
Cutting-edge WiFi 6 (AX) router, engineered for a powerful and seamless online experience with support for speeds of up to 2.5G, setting a new standard for connectivity. With its advanced technology and high-quality components, this router ensures lightning-fast speeds and incredibly low latency, guaranteeing that all your online activities, from streaming to gaming, are smooth and uninterrupted. Say goodbye to buffering and lag, and embrace a top-tier surfing experience with quality WiFi 6 (AX) router.
Package Contents:
LED Indicators:
Connect the Hardware
- Place your HT-360AXG router.
- Remove the GPON case cover by pushing it to the right side.
- Connect the fiber cable to the GPON port on the router.
- Route the fiber cable through the designated area and close the cover.
- Connect the supplied power adapter to the router and a power outlet.
- Turn on the router by pressing the power button and wait approximately one minute until the router finishes the initial startup.
- Download the Home Pass® by Plume app and launch it.
Follow the instructions in the app.
In the app, you will be able to manage your wireless home network, including configuring the name and password of your Wireless Network (SSID), and enjoy cyber protection and much more.
Back Panel
FCC Regulations:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
This device has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiated
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
FCC Note:
Caution: Changes or modifications not expressly approved by the party
responsible for compliance could void the user‘s authority to operate the
equipment.
RF Exposure Information
This device meets the government’s requirements for exposure to radio waves.
This device is designed and manufactured not to exceed the emission limits for
exposure to radio frequency (RF) energy set by the Federal Communications
Commission of the U.S. Government. This device complies with FCC radiation
exposure limits set forth for an uncontrolled environment. In order to avoid
the possibility of exceeding the FCC radio frequency exposure limits, human
proximity to the antenna shall not be less than 20 cm during normal operation.