TAC 3S-N118T Side Steps Running Boards Instruction Manual
- June 1, 2024
- TAC
Table of Contents
TAC 3S-N118T Side Steps Running Boards
Product Specifications:
- Compatibility: 2005-2024 Nissan Frontier Crew Cab, 2005-2012 Suzuki Equator Crew Cab
- Part Number: 3S-N118T
- Includes: 1 Driver/Left Side Bar, 1 Passenger/Right Side Bar, Mounting Brackets, Bolts, Washers, Lock Washers, Nuts
Product Usage Instructions
Waxing and Maintenance
After installation, wax the product to protect it. Use mild soap for cleaning.
For stainless steel finishes, you may use aluminum polish for scratches.
Periodic Inspections
Regularly inspect the installation to ensure all hardware is= secure and
tight.
Frequently Asked Questions (FAQ)
Q: Can I use any type of polish or wax on the product?
A: Avoid using products containing abrasives that could damage the finish. For
stainless steel finishes, aluminum polish can be used for scratches.
INSTALLATION INSTRUCTIONS
3” SIDE BAR
2005-2024 NISSAN FRONTIER CREW CAB 2005-2012 SUZUKI EQUATOR CREW CAB PART# 3S-
N118T
PARTS LIST
| 1 | Driver/Left Side Bar | 12 | 8-1.25mm x 30mm Hex Bolts |
|---|---|---|---|
| 1 | Passenger/Right Side Bar | 24 | 8 x 24mm OD x 2mm Flat Washers |
| 3 | Left Offset Mounting Brackets | 24 | 8mm Lock Washers |
| 3 | Right Offset Mounting Bracket | 12 | 8-1.25mm Hex Nuts |
PROCEDURE
- REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY.
- Remove the existing factory running boards or side steps if equipped. Place Brackets on the ground in the order as pictured above.
- Select the driver side front Mounting Bracket, (Figure 1A). Attach the Bracket to the threaded studs at the front mounting location, (Figure 1B), with the included (2) 8mm Flat Washers, (2) 8mm Lock Washers and (2) 8mm Hex Nuts. Do not tighten at this time. IMPORTANT: Top mounting holes in Brackets are off set toward the front or back, (Figures 1A and 2A). Use the illustrations to select the proper Mounting Bracket for each location.
- Repeat Step 3 for the driver side center, (Figures 2A and 2B), and rear Mounting Bracket installation, (Figures 3A & 3B). IMPORTANT: Use the illustrations to select the proper Mounting Bracket for all locations. Center Bracket installation is unique.
- Carefully place the driver Sidebar onto the Mounting Brackets. Bolt the Sidebar to the Brackets with the included (6) 8mm Hex Bolts, (6) 8mm Lock Washers and (6) 8mm Flat Washers,
- Level and adjust the Sidebars as desired and tighten all hardware.
- Repeat Steps 2 – 6 for passenger Sidebar installation.
- Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing
is recommended to add a protective layer over the finish. Do not use any type
of polish or wax that may contain abrasives that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and
scuffs on the finish. Mild soap may be used also to clean the Sidebar.
For gloss black finishes: Mild soap may be used to clean the Sidebar.
Driver Side Installation Pictured
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>