Ancre DESIGNS LEDM-FRYSTA-30-RD Dimmable LED Lighted Frosted White Round Fog Instruction Manual

Table of Contents

Fog

Ancre-DESIGNS-LEDM-FRYSTA-30-RD-Dimmable-LED-Lighted-Frosted-White-Round-
Fog-PRODUCT

How to use the Defogger Switch and Dimmer Switch?

Short Touch Button (<1s) to turn the task light on/off then long touch (>1s) to dimming from 15% to 100% and cycle.
Press the Button to turn the defogger on and off.

NOTE: Use warm soap water and a soft, damp, lint-free cloth to clean the mirror. Wipe dry with another clean cloth. Glass cleaner can be used on the mirror surface when required. Avoid scourers, abrasives and chemical cleaners as they can damage the glass and the frame.
In hard water areas, limescale may deposit the glass. Regular cleaning will minimize this problem. If this build-up becomes increasingly difficult to remove, apply a small amount of white vinegar on the area.
Do not attempt to cut the glass.
Do not hit the glass with a hard or sharp article.

Please read follow warm tips before installation:

Power off the electrical before installation. Use a voltage detector to make sure. Verify the circuit breaker is turned off & lock it in case someone tries to turn it on.
If you’re NOT experienced in installing electrical wiring, then hire a professional electrician. Your safety is more important than saving a few dollars.
Avoid water at all times when working with electricity. Never touch or install any electrical equipment or circuits with wet hands.
Tools you will need: voltage tester, wire cutters, wire and cable strippers, needle nose pliers, continuity tester, and wire closure.
Wear Safety Glasses and Protective Clothing to protect you from sparks.

$Ancre-DESIGNS-LEDM-FRYSTA-30-RD-Dimmable-LED-Lighted-Frosted-White-Round- Fog-FIG-1 $3$$

$Ancre-DESIGNS-LEDM-FRYSTA-30-RD-Dimmable-LED-Lighted-Frosted-White-Round- Fog-FIG-1 $4$$

Installation Instructions:

ATTENTION: Ensure that power is off at the fuse box or circuit breaker before installation.
- Step 1: Mark the position of the screw through the wall-mounted brackets on the wall, making sure that the brackets are levelled horizontally.
- Step 2: Drill the holes.
- Step 3: Tap the four wall anchors provided into the holes drilled in step 2. $Ancre-DESIGNS-LEDM-FRYSTA-30-RD-Dimmable-LED-Lighted-Frosted-White-Round-Fog-FIG-1 $5$$
- Step 4: Secure the wall-mounted brackets with the screws provided.
- Step 5: Connect the power cord with the wire connectors provided and hang the mirror up to the wall-mounted brackets. $Ancre-DESIGNS-LEDM-FRYSTA-30-RD-Dimmable-LED-Lighted-Frosted-White-Round-Fog-FIG-1 $6$$

Read User Manual Online (PDF format)

Loading......