BUXVRCS 19.68 Inch Flush Mount Caged Ceiling Fan with Lights User Manual
- May 15, 2024
- BUXVRCS
Table of Contents
BUXVRCS 19.68 Inch Flush Mount Caged Ceiling Fan with Lights
Attention
- To avoid potential electric shock, the home main power supply must be shut off before installation.
- Please pay attention to checking whether the wires were in good condition before installation.
- All wiring must be carried out under national and local specifications, please hire or consult a licensed electrician to ensure that the live, neutral, and ground wires are connected correctly.
- Please do not refit this ceiling fan light fixture, which may damage it.
- All screws must be checked and re-tightened if necessary before operating the ceiling fan light fixture.
Installation Steps
-
Step 1: Loosen the screws which connected the hanging plate and light fixture, but don’t take them off, then take the hanging plate from the ceiling fan light fixture.
-
Step 2: Marking/locating the hole position on the ceiling by borrowing the hole position of the hanging plate.
-
Step 3: If you have a wooden ceiling, use type 1 screw, if you have a concrete ceiling, use type 2 screws, then according to the size of the screw type, punch suitable size holes at the hole marks, then install the hanging plate. (Pic. 1)
Step 4: Install bulbs -
Step 5: Connect wires: Connect the black live wire marked “L” on the light fixture to the live wire (typically black) on the socket box. b. Connect the white neutral wire marked “N” on the light fixture to the neutral wire (typically white) on the socket box. c. Connect the ground wire (copper color bare wire) from the base of the light fixture base with the ground wire (bare wire) of the socket box.
-
Step 6: Assemble the ceiling fan light fixture to the hanging plate, tighten the screws, and complete the installation.
- Main switch
- Turn on/off light
- Natural wind
- Set fan speed
- Forward
- Reversal
- Timing for 4 hour
- Battery type: AAA(not included)
Warm Tips:
If your remote controller is not controlling the ceiling fan light fixture, please refer to the following steps to undo the fault.
- replace the battery of the remote controller.
- try to re-pair the remote controller and the ceiling fan light fixture
- turn off the ceiling fan light fixture via the wall switch/main power supply and turn it on again
- long-press the pair key 2H button within 5 seconds after turning it on again
- If you hear the beep sound twice, the repair is successful
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>