Moon-De-Age BKLVGL00202 Low Voltage LED Bollard Light Instruction Manual
- June 14, 2024
- Moon-De-Age
Table of Contents
Moon-De-Age BKLVGL00202 Low Voltage LED Bollard Light Instruction Manual
INSTRUCTIONS
BKLVGL00202
BKLVGL002301
Two optional installation ways:
- Use 4 screws and punch them directly through the hole into the ground.
- Use plastic stake connect with the end of the bollard tightly, then fix the bollard to the ground by the stake
ITEMS MUST BE PURCHASED SEPARATELY
CONNECTOR/SUPPLY ASSEMBLY
Grip top of connector (Part B) and pull up while pressing down on lever to
open. Slide supply cable (sold separately) across the middle of the connector
until it rests between the two metal teeth. Snap connector closed, making sure
both teeth evenly puncture and penetrate the cable. Connect completed assembly
to the transformer (sold separately
TROUBLESHOOTING
| PROBLEM | POSSIBLE CAUSE | SOLUTION |
|---|---|---|
| Lights will not come on. | A. Transformer (sold separately) not connected |
or power turned off. separately) not
B. Supply cable (sold separately) improperly attached to connector.
C. Supply cable (soldD. Artificial punctured by teeth inside connector.
light interfering with photo sensitive cell on transformer.| A. Connect
transformer, plug in outlet and turn on power.
B.Check connection to connector on each light
C. Verity that connector teeth have punctured both sides of supply cable.
D. Mount transformer (sold separately) in a better location.
FCC WARNING
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user authority to operate the equipment.
Notes: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to a radio or television reception, which can be deternined by turing the equipment offand on the usef 1s encouraged to try to correct the nterference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase th separation between the equipment and receiver.
- (Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
If any further query, please contact us by mailing below address: moondeage
service@outlook.com. Thank you!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>