taurus Ice Brise Silence Instruction Manual

: June 1, 2024
: taurus

Table of Contents

Ice Brise Silence
DESCRIPTION
USE AND CARE
INSTALLATION
INSTRUCTIONS FOR USE
Documents / Resources

Ice Brise Silence
Instruction Manual taurus Ice Brise Silence

ICE BRISE SILENCE

Ice Brise Silence

taurus Ice Brise Silence - feager

STAND FAN ICE BRISE SILENCE

DESCRIPTION

A Front grill
B Fixing belt
C Security screw
D Propeller nut
E Propeller
F Grill nut
G Rear grill
H Motor shaft
I Motor housing
J Fan head
K Control panel
L Upper lock nut
M Supply cord
N Top tube
O Lower lock nut
P Bottom tube
Q Base
R Base’s screw washer
S Base’s screw
T Remote control

Control panel (K)

Swing button
Speed selection button
On/Off button
Display

Remote control (T)
a On/Off button
b Timer button
c Increase Speed/Time button
d Decrease Speed/Time button
e Swing button
f Low wind mode – Speed 3
g Medium wind mode – Speed 15
h High wind mode – Speed 24

USE AND CARE

Fully extend the appliance’s supply cord before each use.
Do not use the appliance if the on/off button does not work.
Do not use the appliance if the speed selection buttons do not work.
Do not move the appliance while in use.
Do not use the appliance if it is tipped up and do not turn it over.
Do not turn the appliance over while it is in use or connected to the mains.
Disconnect the appliance from the mains when not in use and before undertaking any cleaning task.
Store this appliance out of reach of children and/or persons with physical, sensory or reduced mental or lack of experience and knowledge.
Keep the appliance in a dry, dust-free place, out of direct sunlight.
Make sure that dust, dirt or other foreign objects do not block the fan grill on the appliance.
Keep the appliance in good condition. Check that the moving parts are not misaligned or jammed and make sure there are no broken parts or anomalies that may prevent the appliance from operating correctly.
Never leave the appliance connected and unattended if is not in use. This saves energy and prolongs the life of the appliance.
Do not use the appliance to dry pets or animals.
Do not use the appliance to dry textiles of any kind.

INSTALLATION

Be sure to remove all packaging material from inside the appliance.
Ensure that the fan is switched off from the supply mains before start any installation or assembly operation.
Do not remove the support base of the appliance.
Ensure that the appliance is level with respect to the floor.
Do not cover or obstruct the sides of the appliance and leave a minimum space of 40cm front other walls, ceiling…
The plug must be easily accessible so it can be disconnected in an emergency.
The appliance should be used with its base fitted.

ASSEMBLING THE BATTERY/S OF THE REMOTE CONTROL

This appliance uses a 3V CR2025 battery.
Caution: During the handling of batteries, do not touch both poles at the same time, as this will provoke the partial discharge of the stocked energy therefore affecting longevity.
Remove the cover of the batteries compartment.
Check that the plastic covering that protects the batteries has been removed (some batteries are sold with a protective covering).
Put the batteries in its compartment, respecting the polarity.
Replace the cover of the battery compartment.
It is essential that the batteries should always be the same kind and the same charge. Never mix alkaline batteries with Carbon-Zinc ones and/or rechargeable ones.
Non-rechargeable batteries are not to be recharged.
DO NOT charge rechargeable batteries while they are still in the appliance as it may cause internal gas or heat generation, resulting in an explosion or possibly a fire that could cause serious injury or property damage.
To preserve battery life, remove the batteries when it’s not being used, and is not expected to be used for extended periods of time.
WARNING: Danger of explosion if the battery is incorrectly replaced.
WARNING: DO NOT INGEST THE BATTERY; CHEMICAL BURN HAZARD. This product contains a coin/button cell battery. If the coin/button cell battery is swallowed, it can cause several internal burns in just two hours and can lead to death.
Keep new and used batteries away from children. If the battery compartment does not close securely, stop using the product and keep it away from children.
If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.
If the coin cell battery contents come into contact with the skin, immediately wash the area with mild soap and water. If coin cell battery liquid gets into the eyes, rinse them with water over the open eye for 15 minutes or until irritation ceases. If medical attention is needed, the battery electrolyte is composed of an organic solvent and lithium salts.
Do not incinerate or dispose of tool together with household waste material! Tool that has reached the end of its life must be collected separately and returned to an environmentally compatible recycling facility.

ASSEMBLING THE BASE

Fit the base with the bottom tube and secure it with the screw provided (R-S).
Stand the base up again so as to check that the base works properly.
Fit the appliance with the top tube, and then with the bottom tube, and secure it by using the lock nuts (L-O).

ASSEMBLING THE GRILL AND THE PROPELLER

Fit the rear grill (G) on the motor housing (I), matching their fitting points.
Tight the grill nut (F) that attaches the grill. Make sure of a correct setting.
Fit the propeller (E) On the motor shaft (H).
Tight the propeller nut (D) that attaches the propeller, Make sure of a correct setting.
Fit the front grill (A) front the rear grill (G). Fix the front grill turning around its fixing belt and tight the security screw by using a screwdriver.
Check the correct rotation of the propeller.

INSTRUCTIONS FOR USE

BEFORE USE

Make sure that all product’s packaging has been removed.
Please read carefully the “Safety advice and warnings” booklet before first use.
Prepare the appliance according to the function you wish to use.

USE

Extend the supply cord completely before plugging it in.
Connect the appliance to the mains.
Guide the appliance to direct the flow of air in the desired direction.
Turn the appliance on, by using the on/off button, in the control panel (3) or by the remote control (a).
The current speed appears in the display (4).
Select the desired speed by pressing the increase (c ) or decrease (d) button, or increase the speed by repeatedly pressing the speed button on the control panel (2) until the desired speed is reached.

FAN FUNCTION

You can select the speed by two ways:
– By selecting the desired speed (1-24) manually.
– By selecting the desired predefined mode (f-g-h).

TIMER FUNCTION

The appliance’s operating time can be controlled. (1-18h).
To program the operating time simply select it using the (b) button on the remote control, and then press the increase button (c) or the decrease button (d) until the desired time is reached.
The time blinks on the display (4) during your selection.
When the time stops blinking and appears the speed on the display again, means it is programmed.
Once the selected time has elapsed, the device will turn off automatically.

OSCILLATION FUNCTION

The oscillation function makes it possible to direct the flow from the apparatus so that it automatically alternates over a range of 75º.
To activate this function, press the (e) button on the remote control or (1) in the control panel.
To deactivate this function, press again the swing button.

HEIGHT ADJUSTMENT

The appliance height can be adjusted, it’s just necessary to unlock the lock nuts (L-O) place the appliance at the desired height adding or removing tubes as needed and lock again the nuts (L-O).

ONCE YOU HAVE FINISHED USING THE APPLIANCE

Turn the appliance off, using the on/off button.
Unplug the appliance from the mains.
Clean the appliance.

CLEANING

Disconnect the appliance from the mains and allow it to cool before undertaking any cleaning task.
Clean the equipment with a damp cloth with a few drops of washing-up liquid and then dry.
Do not use solvents, or products with an acid or base pH such as bleach, or abrasive products, for cleaning the appliance.
Never immerse the appliance in water or any other liquid or place it under running water.
If the appliance is not in good condition of cleanliness, its surface may degrade and inexorably affect the duration of the appliance’s useful life and could become unsafe to use.

www.taurus-home.com
03/04/2024 – Page Size A5