motorola E17965 Bone Conduction Speaker User Manual
- June 1, 2024
- Motorola
Table of Contents
Motorola Speaker
User Manual
Buttons:
- Lanyard hole
- Function button
- Mic slot
- LED Indicator
- Charging port (Type)
- Power/Mode button
- Suction cup/adhesive sticker to fix
Single Speaker Operation:
- Press and hold the power key unt il you hear the voice indicate “Poweron.”
- Turn on your phone’s BT and search for “Motorola Speaker” to pair.
- Once connected, place the speaker on the surface of any hollow object to play.
You will get different sound effects from different hollow objects.
Double Speaker Stereo (TWS) Operation:
If you have 2 speakers, they can be paired together.
Turn both speakers on at the same time and wait for 3-5 seconds, the speakers
will pair to each other automatically. (One of the two speakers must be paired
to BT)
Charging:
The charging cable can be used with a regular USB 5V charger. It is not compatible with a fast charger, especially with 9V 12V and other chargers whose output voltage is higher than 5V.
LED indicator:
When charging, the red LED will be lit. Once charged, the red LED light will
turn off. When the BT mode is turned on, the LED blue light will blink. Once
paired, the blue light will be always on.
Model: E17965
Made in Shenzhen, China
FCC ID :2ARZK-E17965
FM Function:
- Short-press the Power button to switch from BT mode to FM mode.
- Long-press the Function button to search FM channels automatically.
- After searching is finished, short press the “Function” button to switch to the radio station.
- FM Volume control: Single click the “Function” button to go down, double click to go up, and triple click the switch to get to the next stored station.
(* Suggested to use FM function outdoors, plug in USB cable as well to amplify the FM signal)
Tips:
Before starting, peel off the protection film on the stick pad on the bottom
of the speaker, then place the speaker on to the surface of any hollow object.
Use a pin to assist when placing the lanyard through the hole
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
The Brandit Agency
1175 19th Street Vero Beach, FL 32960
customerservice@teambrandit.com
and/or 877-567-917
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>