SEALEY TDMCRW TIE Down Motorcycle REAR wheel Instruction Manual
- June 1, 2024
- SEALEY
Table of Contents
INSTRUCTIONS FOR
TIE DOWN – MOTORCYCLE REAR WHEEL
MODEL NO: TDMCRW
TDMCRW TIE Down Motorcycle REAR wheel
Thank you for purchasing a Sealey product. manufactured to a high standard,
this product will, if used according to these instructions, and properly
maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE
OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND
WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE
DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE
INSTRUCTIONS SAFE FOR FUTURE USE.
| Refer to instructions
---|---
SAFETY
When selecting web lashings (tie
downs) consideration must be given to the required lashing capacity, taking
into account the mode of use and the nature of the load to be secured.
Tie downs must be strong enough
and of the correct length for the mode of use.
Take care that the load is
stable when the tie down is released.
Avoid exposure of the tie down
to chemicals.
Do noT use if tie down is damaged. A visual inspection before use is
recommended.
Avoid sharp edges. Protect tie
downs by using sleeves or corner protectors.
Do noT overload.
Do noT use if knotted.
INTRODUCTION
Manufactured from polyester webbing. Stitched reinforcement at joins and loops. Suitable for workshop use or for securing motorcycle to flatbed or trailer. Secures rear wheel to anchor point without compressing the suspension units, thus reducing the risk of seal damage. ratchet mechanically tensions the webbing using a simple drum and ratchet mechanism for superior load restraint.
SPECIFICATION
Model no……………………………….. tdmcrW
Maximum tension ………………….. 500Kg
Load test ……………………………….. 1000Kg
Webbing Width ……………………… 35mm
OPERATION
4.1. Position straps around rear wheel as shown in fig 2.
4.2. Attach hook fig 3. to anchor point so as to pull the bike forward.
4.3. using ratchet tighten strap until wheel is clamped into position.
STORAGE
5.1. Always store in a dry place.
MAINTENANCE
6.1. Use a light duty oil on the gears and slides to keep the ratchet operating properly.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools,
accessories and packaging should be sorted, taken to a recycling centre and
disposed of in a manner which is compatible with the environment. When the
product becomes completely unserviceable and requires disposal, drain any
fluids (if applicable) into approved containers and dispose of the product and
fluids according to local regulations.
Note: it is our policy to continually improve products and as such we
reserve the right to alter data, specifications and component parts without
prior notice.
Important: no liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is
required for any claim.
Sealey group, Kempson way, Suffolk Business park,
Bury St Edmunds, Suffolk. Ip32 7Ar
01284 757500
01284 703534
[email protected]
www.sealey.co.uk
© Jack sealey limited