Shenzhen Anruiwei Electronic Technology Co Ltd ARW-CX-033 Wireless Charger for Mobile Phone Instructions
- June 1, 2024
- Shenzhen Anruiwei Electronic Technology Co Ltd
Table of Contents
Shenzhen Anruiwei Electronic Technology Co Ltd ARW-CX-033 Wireless Charger for Mobile Phone
Product parameters
Name
Wireless Charger for mobile phone (headset)
Output
5W 7.5W 10W 15W(MAX)
Product dimensions
φ60×7.8mm
Input
5V/2A 9V/2A
Material
Cellulose acetate
Charging port
USB-C
Tips
- Recmmended:PD20W or above power adapter(sold separately).
- This product has an input overcurrent and overvoltage protection function, lf it is used improperly it will shut down or reduce the output power, please check whether the device is abnormal or used improperly
- Keep the ambient temperature at 0-25℃, Do not put the product in water, fire, high temperature(>40℃<) or low temperature(>20<) environment, keep it away from children.
- Please use a dry soft cloth to clean the surface, do not use chemicals, soap or detergent to clean.
- Improper use or improper placement may reduce the life of the product or damage it, which is not covered by the warranty.
Product analysis
Application Scenarios
When charging, the center of the watch should be aligned with the center of
the charging position, then it can be charged wirelessly. If the watch can not
be charged normally, adjust the position of the watch until the watch can be
charged.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
This device has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This device generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this device does cause harmful interference to
radio or television reception, which can be determined by turning the device
off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the device and receiver.
- Connect the device into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
The distance between user and products should be no less 20cm.