VOLLRATH R38775 Cafeteria Breath Guard Instruction Manual

Table of Contents

Specifications

One Piece Breath Guard Installation

Install the breath guard uprights (A) to the studs (B) securing with cap nuts (C) as shown in Figure 1. Repeat for all four uprights.

Three Piece Breath Guard Installation

Install the breath guard uprights (A) to the studs (B) securing with cap nuts (C) as shown in Figures 1 and 2. Repeat for all four uprights.
Install the breath guard support tube (D) between the uprights (A) securing with cap nuts (C). Repeat on the other side.
Install the one piece breath guard (E) securing with screws (F) and cap nuts (C) as shown. Repeat for all four mounting locations.
Install the side breath protector (G) to the support tube (D) securing with cap nuts (C) as shown. Repeat on the other side.

Q: What should I do if I accidentally over-tighten the cap nuts during installation?
- A: If you accidentally over-tighten the cap nuts and notice cracking in the plastic, stop immediately to prevent further damage. Contact customer service for assistance.
Q: Can the breath guard be adjusted after installation?
- A: Yes, you can adjust the position of the breath guard components after installation by loosening the cap nuts slightly and repositioning as needed.

These instructions cover the installation of the one pice Cafeteria Breath Guard and the three piece Cafeteria Breath Guard.

Some units are shipped with a breath guard not installed. To install the breath guard follow these steps:

NOTE:

Use caution when tightening the cap nuts. Overtightening may cause the plastic to crack.

Install the breath guard uprights (A) to the studs (B) securing with cap nuts (C) as shown. See Figure 1. Repeat for all four uprights. $VOLLRATH-R38775-Cafeteria-Breath-Guard-fig $1$$
Install the breath guard support tube (D) between the uprights (A) securing with cap nuts (C) as shown. Repeat on the other side.
Install the one piece breath guard (E) securing with screws (F) and cap nuts (C) as shown. Repeat for all four mounting locations.
Install the side breath protector (G) to the support tube (D) securing with cap nuts (C) as shown. Repeat on the other side.

Some units are shipped with a breath guard not installed. To install the breath guard follow these steps:

NOTE:

Use caution when tightening the cap nuts. Overtightening may cause the plastic to crack.

Install the breath guard uprights (A) to the studs (B) securing with cap nuts (C) as shown. See Figures 1 and 2. Repeat for all four uprights. $VOLLRATH-R38775-Cafeteria-Breath-Guard-fig $2$$
Install the breath guard support tube (D) between the uprights (A) securing with cap nuts (C) as shown. Repeat on the other side.
Install the side breath guards (E) securing with screws (F) and cap nuts (C) as shown. Repeat for all mounting locations.
Install the side shield (G) to the support tube (D) securing with cap nuts (C) as shown. Repeat on the other side.
Install the support bar and stud assembly (H) to the side breath guards (E). Repeat for all mounting locations.
Install the top breath guard (I) to the support bar and stud assembly (H) securing with cap nuts (C). Repeat for all mounting locations.