FUYUAN FTDBF00EN Multi Frequency Remote Control Duplicator Instruction Manual
- June 1, 2024
- FUYUAN
Table of Contents
FUYUAN FTDBF00EN Multi Frequency Remote Control Duplicator
Operating instructions
- Press and hold the first button of the multi frequency copying remote control, press the second button three times and release both hands. The LED light will flash slowly, indicating that the remote control regeneration function has been entered. At this time, hold down a certain button with the original factory remote control and approach the multi frequency copying remote control. The LED light will flash quickly to indicate successful regeneration. At this time, press any key of the multi frequency copying remote control and select which button you want to regenerate on. The LED light will remain on and then turn off, indicating that the regeneration is complete.
- Press and hold the second button of the multi frequency copy remote control, press the first button three times and release both hands. The LED light will flash slowly to indicate that the remote control copy function is entered. At this time, hold down a certain button with the original factory remote control and approach the multi frequency copy remote control. The LED light will flash quickly to indicate that the copy is successful. At this time, press any key of the multi frequency copy and select which button you want to copy on. The LED light will remain on and then go off to indicate that the copy is complete.
- Copyable codes: can copy almost all common fixed codes and scrolling codes on the market;
- Battery replacement: If the remote control is in the transmitting state and the LED flashes slowly and cannot be controlled, it indicates that the battery is out of charge. Please ask the customer to replace the battery.
Technical parameter
- Launch mode: ASK
- Frequency (reproducible frequency): 433.92MHz
- Frequency error range of copying: within ± 200KHZ
- Working voltage: 2.5V-3.3V
- Static current: less than 1 microampere
- Working current: 22mA
- Transmission power: -10dbm
Warning : Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE : This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>