TacticalGears PLU-144740 High Light Solar Security Sensor Light Instruction Manual
- June 1, 2024
- TacticalGears
Table of Contents
TacticalGears PLU-144740 High Light Solar Security Sensor Light
Specification
Components/Dimension
Installation
- Step A : According to the spacing of two screw bits on the bracket, drill two mounting holes on the installation place. (Shown on Figure 1)
- Step B : Put the bracket onto the panel, match screw bits with the drilled holes and screw up. (Shown on Figure 2)
- Step C : Align the lamp body with the hole on the mounting bracket and buckle it directly.(Shown on Figure 3)
Remote control function introduction
- Mode 1 : If movement is detected at dusk, the solar lamp lights up super bright. If no movement is detected, the solar lamp does not light up.
- Mode 2 : If movement is detected at dusk, the solar lamp lights up super bright. If no movement is detected, the solar lamp lights up weakly.
- Mode 3 : Solar lamp remains lights up weakly, regardless of whether movement is detected at dusk.
- Mode switch button : 3 modes cyclically switch
Test Before Usage
- The light should be exposed to direct sunshine for eight hours to ensure it’s sufficiently recharged.
- Test the light by covering the solar panel.
- The switch should be set to ON before installation.
Tips
The detection distance depends on ambient temperature. If the ambient temperature is closer or higher than human body temperature, the detection distance is shorter, which means you need to get closer to be detected If the ambient temperature is lower than human body temperature, the detection distance is farther.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>