DARUITE Window Film Privacy Frosted Installation Guide

Table of Contents

DARUITE-Window-Film-Privacy-Frosted-product

Specifications

Clean and Wet the Glass
- Thoroughly clean the window surface to remove any dust particles.
- Generously spray water across the entire glass area to ensure proper adhesion.
Measure and Cut the Film
- Measure the Static Cling film and cut it with an additional 0.5-1 inch margin on all sides.
Remove the Backing Film
- Peel off the backing film carefully. Optionally, attach two pieces of Scotch Tape to a corner of the smooth side for easier handling.
Spray Water Generously on Film’s Static Side
- Apply a liberal amount of water on the static side of the film. Adding 2-3 drops of shampoo to the water can enhance adhesion.
Adhere the Film to the Glass:
- Re-spray the glass before applying the film to facilitate positioning.
- Start applying the wet film on the window from the top and lightly spray water on the film to aid in smooth application.
Smooth Bubbles
- Secure the film by squeegeeing from the center to the edges, ensuring all water and air bubbles are removed for a smooth finish.
Trim Excess Edges
- Slowly trim any excess film using a squeegee as a guide. Re-spray the film if needed and repeat the squeegee process for a clean edge.
Seal and Dry
- Fold a cleaning cloth over the squeegee to eliminate surplus water from both the film and the window frame.

If you encounter any issues during installation, please contact our customer service at cs@dofirst.net for assistance.

Frequently Asked Questions (FAQ)

Q: Can I reposition the film once it’s applied?
A: It is recommended to position the film correctly during installation as repositioning may affect adhesion and result in bubbles.
Q: How long does it take for the film to dry completely?
A: The film typically dries within 24-48 hours, depending on humidity levels and application thickness.
Q: Can I use a different solution for spraying other than water?
A: Water is recommended for optimal adhesion, but if needed, a mild soap solution can also be used.

Thank you for choosing our window film. Before initiating the installation, carefully review the following instructions.

Inside the plastic tube, discover three complementary tools provided to facilitate the installation process.

Clean and Wet the glass
- Thoroughly clean the window, ensuring the surface is free from dust.
- Generously spray water across the entire glass area.
Measure and Cut the Film:
- Measure the Static Cling film and cut it with an additional 0.5-1″ margin on all sides. $DARUITE-Window-Film-Privacy-Frosted- $2$$
Remove the Backing Film:
- Peel off the backing film. Optionally, attach two pieces of Scotch Tape to a corner of the smooth side or directly adhere the film onto the glass.
Spray Water Generously on Film’s Static Side:
- A more liberal application solution enhances adhesion. Adding 2-3 drops of shampoo to the water can be advantageous.
Adhere the Film to the Glass:
- Re-spray the glass before applying the film.
- Position the wet film on the window starting from the top.
- Lightly spray water on the film.
Smooth Bubbles:
- Secure the film by squeegeeing from the center to the edges, removing all water and air bubbles. $DARUITE-Window-Film-Privacy-Frosted- $4$$
Trim Excess Edges:
- Slowly trim any excess film, guided by the squeegee. Re-spray the film if necessary. Repeat the squeegee process.
Seal and Dry:
- Fold a cleaning cloth over the squeegee.
- Eliminate surplus water from both the film and the frame.