GREPSPUD LS-QC0010-2 Trailer Idler Hub Kit Installation Guide

**GREPSPUD LS-QC0010-2 Trailer Idler Hub Kit Installation Guide

**

HOW TO CONFIRM THAT YOU CAN REPLACE

Measure Your Hub Bolt Pattern
NOTICE: Take the 5-lug hub as an example, if the length of measurement is 4.5″, and as there are 5 lugs, then the bolt pattem is 5×4.5″

5 lug is from the OUTERMOST point of a hole TO the CENTER of another hole

**Confirm Bearing and Spindle Sizes

**

NOTICE: Verify that the bearing model are L68149 and L44649.
Verify your spindle is 1-1/16″ to 1-3/8″ Trailer Axles 3500lb #84 Spindle.
Both round and square spindle can be used.

PACKAGE INCLUDE & DIMENSION

• L68149 INNER BEARING
  

• L44649 OUTER BEARING
  

• GREASE SEAL
  

• WASHER
  

• COTTER PIN
  2.3″
  

• LUG NUT
  1/2″-20 THREAD
  

• DUST
  1.98″ O.D DUSTCAR FOR

• RUBBER PLUG
  FOR 1.18″ HOLE
  

• SPINDLE NUT
  FOR SPINDLE WITH 1″ THREAD
  

HOW TO INSTALL

Step 1 : Install L68149 bearing

Step 2: Install grease seal

Step 3: Install hub

Step 4: Install L44649 bearing

Step 5: Install washer

Step 6: Install spindle nut

Step 7: Install cotter pin

Step 8: Install dust cap”

Step 9: Install lug nuts

NOTICE

• Please measure your hub dimensions before installation. This can effectively avoid the case of failure to install.
• For whatever reason, if you are not satisfied, please do not hesitate to contact us if you have any questions.
• You can contact us through e-mail: GREPSPUD@outlook.com
  

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>