TYPE S ML-58260 Tri-Beam Multi-Directional LED Strips Instruction Manual
- June 4, 2024
- TYPE S
Table of Contents
TRI-BEAM
MULTI-DIRECTIONAL
LED STRIPS
Instruction Manual
PACKAGE CONTENTS
24” Tri-Beam Multi-Directional Multicolor LED Strips with Controller
TECHNICAL SPECIFICATION
Working voltage:
DC 12V only
Maximum amperage draw:
0.41A
Watt:
5W
LEDs:
9 x 5050 RGB per strip
18 x 2080 White LED per strip
INSTALLATION
- Choose your desired location. (Refer to suggested locations on the right.)
- Clean surface thoroughly with isopropyl alcohol.
- Peel off the 3M™ tape backer and carefully apply to the desired area.
NOTE:
- For use with 12V power only.
- Suitable temperature for installation is 70°F (21°C) or above.
- If needed LED strips can be cut – ONLY cut where scissors mark is shown.
Note the portion of strip that is cut-off is no longer usable.
Recommended locations:
Peel off the 3M™ tape backer and carefully apply to the desired area.
POWER
Plugs into any 12V power socket and press
the ON/OFF switch to turn on.
OPERATION
A Power Button
B Color Button
C Mode Button
- Press the Power Button to turn the LED strips ON/OFF.
- Press the Color Button to cycle through the following color options:
- Change 15 color options
- Prism mode after the 15 color options
- Press & Hold to turn off RGB LED
- Press the Mode Button to cycle through the following lighting modes:
- Solid Left White LED
- Solid Right White LED
- Solid Left & Right White LED
- Left & Right White LED strobe
- Press & Hold to turn off White LED
WARNING
IMPORTANT SAFETY INSTRUCTIONS
- SAVE THESE INSTRUCTIONS– This manual contains important safety and operating instructions for cigarette lighter adapter of Model LM58260.
- Before using cigarette lighter adapter, read all instructions and cautionary markings.
- Do not expose charger to rain, moisture, or snow.
- Use of an attachment not recommended or sold by the cigarette lighter adapter manufacturer may result in a risk of fire, electric shock, or injury to persons.
- To reduce risk of damage to cigarette lighter adapter and cord, pull by cigarette lighter adapter rather than cord when disconnecting charger.
- Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.
- Do not operate product with damaged cord or cigarette lighter adapter – replace it immediately.
- Do not operate cigarette lighter adapter if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to a qualified service person.
- Do not disassemble the product or cigarette lighter adapter; take it to a qualified service person when service or repair is required. Incorrect reassembly may result in a risk of electric shock or fire.
- To reduce risk of electric shock, unplug cigarette lighter adapter before attempting any maintenance or cleaning. Turning off controls will not reduce this risk.
WARNING: do not install or use product if it, in any way, impairs the safe operation of your vehicle. Follow manufacturer’s instructions to ensure the product is properly & safely installed. Neither the manufacturer nor the reseller can be held responsible or liable for consequential, incidental, or indirect damages to either person or property resulting from the installation or improper use of this product. Check your state or provincial laws before installing.
This product is not DOT approved and is designed for intended use only (for interior cabin). Not for use in extreme temperature such as under hood applications.
This product is intended solely for decorative purposes. Check local laws and regulations regarding installation and use. Manufacturer and seller assume no liability for improper installation or use, which are solely the responsibility of the purchaser.
WARNING: This product can expose you to chemicals including DEHP and DINP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
3M™ is a trademark of 3M Company.
**** Have a comment or question?
Email us at: info@typesauto.com
or visit us online at: www.typesauto.com
Tri-Beam
Multi-Directional Multicolor LED Strips
LM58260
Responsible Party:
TYPE S
2975 Red Hill Ave., Ste. 100,
Costa Mesa, CA 92626, U.S.A.
Tel: 1.866.294.9244
A Horizon Brands Company
2975 Red Hill Ave., Ste. 100,
Costa Mesa, CA 92626, U.S.A.
1.866.294.9244 | info@typesauto.com
© 2021 TYPE S. All rights reserved.
www.typesauto.com
ML-58260_V2
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>