QIHANG YJB-05 Wireless Charger User Manual
- June 1, 2024
- QIHANG
Table of Contents
QIHANG YJB-05 Wireless Charger
Product Information
Specifications
- Model: YJB-05
- Input: DC 5V 1A
- Wireless Charging Output: 2.5W (MAX)
Product Usage Instructions
- Powering On: Connect the device to a power supply using the charging cable to turn it on.
- Charging the Watch: Place the watch in the designated charging area to start the charging process. Once fully charged, remove the watch. During charging, simply take off the watch if you need to stop the charging process.
Frequently Asked Questions (FAQ)
Q: How do I know when the watch is fully charged?
- A: Once the watch is fully charged, most devices indicate this with a visual or audible notification. You can also check the watch’s display for a full battery icon.
Q: Can I charge other devices besides a watch on this wireless charging pad?
- A: The wireless charging pad is designed specifically for charging watches. While it may work with other compatible devices, it is recommended to use it primarily for watch charging to ensure optimal performance.
Usage Instructions
- Input: DC 5V 1A
- Wireless charging output: 2.5W(MAX)
- The device can be powered on by connecting it to the power supply through the charging cable.
- When charging the watch, put the watch in the charging area to start charging, fully charged, just take off the watch, in the charging process, if you need to terminate the charge, you can directly take it off.
FCC
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference,
- this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, under part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used under the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment.
The FCC certification of this device refers to RF exposure testing performed
in typical operating conditions, where a person is no closer than 20
centimeters from the device surface at all times, except for non-repetitive
patterns with transient time intervals in the order of a second. Only in the
stated conditions, the device is shown to fully comply with the FCC RF
Exposure requirements of KDB 447498.