Ohuhu B0BHWFHQCT Gardenova Mini Greenhouse for Indoor Outdoor Instruction Manual
- June 1, 2024
- Ohuhu
Table of Contents
Ohuhu B0BHWFHQCT Gardenova Mini Greenhouse for Indoor Outdoor
Gardenova Mini Greenhouse for Indoor Outdoor
Specifications
Part | Size | Quantity |
---|---|---|
1 | 68.5cm | 16 PCS |
2 | 42cm | 9 PCS |
3 | 44.5cm | 15 PCS |
4 | 54.5cm | 3 PCS |
5 | 43cm | 3 PCS |
6 | 68.5cm | 6 PCS |
B | 4 PCS | |
D | 4 PCS | |
E | 10 PCS | |
G | 1 PC | |
H | 1 PC | |
I | 2 PCS | |
J | 2 PCS | |
K | 6 PCS | |
L | 1 PC | |
G5 | 12 PCS |
Assembly Instructions
Step 1: Install the first part as shown.
Step 2: Install the second part as shown.
Step 3: Install the third part as shown.
Please Note: Label tube #4 is on the front of the greenhouse, and Label tube #3 is on the back of the greenhouse (Label tube #4 is higher than Label tube #3).
Step 4: Install the fourth part as shown.
Please Note: Connectors I and G are at the front, and connectors J and H are at the back. Since the top is not horizontal (high at the front and low at the back), Connectors I and J need to be adjusted at a proper angle.
Step 5: First install the label tube #6 and Connectors G5 together, one tube with 2pcs connectors; Then put the Connecting Tubes and mesh plate K in the corresponding position as shown.
Step 6: Install the PE cover and mesh clips. Each mesh plate is equipped with 2 mesh clips to fix it, in addition, there are 40pcs zip ties that can be freely installed.
FAQ
What is the purpose of Label tube #4 being higher than Label tube #3?
Label tube #4 is higher than Label tube #3 to ensure the proper slope of the
greenhouse roof, allowing for runoff and preventing water accumulation.
How many mesh clips are provided for each mesh plate?
Each mesh plate is equipped with 2 mesh clips to fix it.
Are there any extra parts provided for assembly?
Yes, there are 40pcs zip ties included that can be freely installed for
additional support and securing the PE cover.
What should be done if the top of the greenhouse is not horizontal after
assembly?
If the top is not horizontal (high at the front and low at the back),
Connectors I and J need to be adjusted at a proper angle for even support and
structure integrity.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>