KuKirin ClPro Electric Scooter Instruction Manual

June 1, 2024
KuKirin

KuKirin ClPro Electric Scooter

Attention

  • Please read the following important safety information carefully before use
  • Please wear helmets and other protective equipment when riding this product. Never ride in a place that is unsafe or violates regulations.
  • Do not make dangerous movements or ride with one hand while the car is moving, Keep your feet on the pedals. For your driving safety, Please keep your speed within 2Skm/h. Please avoid riding at night, Please turn on the light if you need to ride at night, And keep the speed of the vehicle at km/h or below.
  • If the road surface is uneven or the road condition is not good, please slow down or push. Avoid riding on slippery roads as much as possible.
  • Do not place the product in water to avoid damage to the electrical part of the vehicle due to water.
  • In bad weather such as rain and snow, please pay attention to driving safety and personal protection.
  • The maximum load of this product is 120kg, Do not overload driving during use.
  • Please avoid using or placing in an environment with high or too-low temperatures. Please do not place this product with flammable materials to avoid fire in the unlikely event of a fire.
  • Users should ride in strict accordance with traffic road regulations, and ride legally under local laws and regulations if there are special local laws.

Warning

  • Check the charger, cable and plug before each charge. If there is any damage, do not use the charger.
  • Check the tyre pressure Before riding, whether the handlebar is installed correctly and tightly, and whether the headlights are clean and free of debris.
  • Make sure the battery is fully charged before riding. If the battery is low during the ride, please keep the vehicle moving slowly and at a constant speed and charge as soon as possible.
  • When braking on wet roads, the braking distance is usually longer than on dry roads. Therefore, brake earlier to stop more safely.
  • Besides, Avoid puddles, wet mud, swamps, water, snow or ice. Do not use electric scooters on rainy, stormy or snowy days. If electrical components (control units, engines, and batteries) are damp or flooded,It can cause irreversible damage and even cause the battery to explode.
  • This product should only be used by one adult at a time. Please do not carry any additional passengers. Do not ride if you are not feeling well or under the influence of alcohol or drugs.
  • The scooter is not a toy. As with any other vehicle, there is a possibility of falling, colliding or encountering other dangerous situations. Please do not send your Electric scooters are available to anyone who doesn’t know how to use them properly. If you let someone else ride your scooter, you are responsible for ensuring all
  • Riders understand all warnings, precautions, instructions and safety precautions and ensure that they can use this product safely and responsibly And protect yourself and others from harm.
  • Electric scooters should be kept away from flammable materials, and open flames.

Diagram

KuKirin-ClPro-Electric-Scooter-fig-1

Parameter

KuKirin-ClPro-Electric-Scooter-fig-2

Packing List

KuKirin-ClPro-Electric-Scooter-fig-3

Accessories

KuKirin-ClPro-Electric-Scooter-fig-4

  • Please carefully check whether the contents in the packing box are complete and intact.
  • If any items are missing or damaged, please contact the seller.

Assembly

Handle install

  1. Remove the tool kit from the accessories, and remove the accessories and installation tools.
  2. Insert the force-holding hole into the telescopic riser.
  3. Lock both sides with MS cylindrical head screws, After turning to a certain extent, adjust the direction of the handle tube and the front wheel, Check for vertical; The upper surface of the force should be aligned with the upper surface of the telescopic riser; Tighten both sides of the screw, Until the handle is stable and does not shake.
  4. Take out the hanging gasket and the hanging screw, and fasten them to the top of the telescopic riser.

KuKirin-ClPro-Electric-Scooter-fig-6

Seat install

  1. Open the seat tube lock.
  2. Align the cushioned saddle tube under the seat cushion into the frame seat tube.
  3. Adjust to your height.
  4. Tighten the nut and snap the handle shut.

Back box install

  1. Use the key to open the back box.
  2. Put the rear box on the rear shelf and adjust the proper position.
  3. Take out the screws and lockout nuts that secure the rear box, and slightly lock the four screws with the nuts.
  4. Check the position of the rear box and tighten the screws until they do not shake.

Instructions

KuKirin-ClPro-Electric-Scooter-fig-9 KuKirin-
ClPro-Electric-Scooter-fig-10

Key Description

KuKirin-ClPro-Electric-Scooter-fig-11

Maintenance

lubrication

  • Please check the scooter body every three months to see if any screws are loose.
  • If they are loose, please tighten the parts that need to be folded every six months and add a small amount of lubricating oil or lubricant for maintenance.

Battery

  • After getting the car for the first time, please fully charge the battery before use, the battery can be charged at any time to ensure that the battery is charged, during this period and will not cause any damage to the battery, please replenish the battery every three months when not in use.

Placement and daily care

  • Do not place the scooter in an excessively low-temperature environment, exposed to sunlight or damp for a long time. Please keep the body surface clean and clean.

Troubleshooting

  • When the instrument self-test finds an error, the error alarm will be issued and displayed on the (speed), and when the error is reported, you can not ride.

KuKirin-ClPro-Electric-Scooter-fig-12

Charging

  1. Open the outer cover of the charging port and insert the charger plug into the charging hole on the car body.
  2. Plug the charger into the power supply.
  3. Make sure the charging plug is correct. When the charger indicator turns green, the battery is fully charged.
  4. Cover with a rubber protective cover after charging.

Warranty

  • The body has logged more than 2,000 kilometres.
  • Normal wear or aging that occurs during the use of the product is not covered by the warranty.
  • If the original identification label of the product is changed or damaged, this warranty will be void.

KuKirin-ClPro-Electric-Scooter-fig-14

Tips: Tires, headlight assembly, instrument cover, handle cover, fender, rear taillight, decorative cover, foot brace, charging port seat and other vulnerable parts are not covered by the warranty policy.

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals