V-TAC VT-1607 ManoMano T8 LED Tubes Instruction Manual

V-TAC VT-1607 ManoMano T8 LED Tubes

TECHNICAL DATA

@Sphere360°
CRI| >80| >80| >80
OF| >0 .5| >0 .7| >0 .7
Beam Angle| 160°| 160°| 160°
Body Type| Plastic| Plastic| Plastic
Holder| G13| G13| G13
Life Span| 25,000 Hours| 25,000 Hours| 25,000 Hours
On/Off Cycles| >15000| >15000| >15000
Dimension| 600x28mm| 1200x28mm| 1500x28mm
Input Voltage| AC:220-240V,50Hz| AC:220-240V, 50Hz| AC:220-240V, 50Hz

This marking indicates that this product should not be disposed of with other household wastes .

Caution, risk of electric shock

PACKING

INTRODUCTION & WARRANTY

Thank you for selecting and buying V-TAC product. V-TAC will serve you the best. Please read these instructions carefully before starting the installing and keep this manual handy for future reference. If you have any another query, please contact our dealer or local vendor from whom you have purchased the product. They are trained and ready to serve you at the best. The warranty is valid for 5 years from the date of purchase. The warranty does not apply to damage caused by incorrect installation or abnormal wear and tear. The company gives no warranty against damage to any surface due to incorrect removal and installation of the product. The products are suitable for 10-12 Hours Daily operation. Usage of product for 24 Hours a day would void the warranty. This product is warranted for manufacturing defects only. The LED tube can be used in hotels, offices, factories, conference rooms, meeting rooms, commercial complexes, residential buildings, schools, colleges, universities, hospitals, etc.

WARNINGS!

• Installation should only be done by a certified electrician
• Operation environment temperature: from -20°C to +45°C
• Do not use DC electricity
• Do not modify the fitting to be used with the LED Tube.
• V-TAC LED Tubes are NOT designed to be used in emergency operations.
• For Indoor use only.
• Do NOT use with electronic ballasts. V-TAC LED tubes are not compatible with electronic ballast circuit. In order to use the electronic ballast fitting you must ensure to remove the electronic ballast from the fitting and rewire the circuit as per new fitting installation as shown below. Ensure the installation and wiring is carried out by certified electrician.

New Fitting Installation

• Installation should only be done by a certified electrician
• Switch Off the power.
• Ensure the wiring diagram is followed as highlighted.
• Insert V-TAC LED Tube.
• Switch On the power to test the light.
  

Installation & Replacement

Installation & Replacement of Fluorescent Lamp(Single Magnetic Ballast Circuit)

• Installation should only be done by a certified electrician.
• Please refer to the wiring diagram for replacing fluorescent tube on a single magnetic ballast circuit with V-TAC LED Tube.
  Wiring Diagram
  

1. Switch off the power

2. Remove the existing fluorescent lamp

3. Remove the existing fluorescent starter

4. Insert LED T8 starter

5. Insert V-TAC LED Tube

6. Switch ON the power

IN CASE OF ANY QUERY/ ISSUE WITH THE PRODUCT, PLEASE REACH OUT TO US AT: SUPPORT@V-TAC.EU FOR MORE PRODUCTS RANGE, INQUIRY PLEASE CONTACT OUR DISTRIBUTOR OR NEAREST DEALERS. V-TAC EUROPE LTD. BULGARIA, PLOVDIV 4000, BUL.L.KARAVELOW 9B

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>