uponor X-24 Base Flexiboard Instruction Manual
- June 1, 2024
- uponor
Table of Contents
uponor X-24 Base Flexiboard
Specifications
- Operating Voltage: 230V
- Power Consumption: 2.1 – 4.2
- Fuse Type: T4.0A
- Dimensions: 8 mm
- Operating Temperature: Varies by model
- Storage Temperature: Varies by model
- Protection Class: Varies by model
- Control Range/Switching Difference: Varies by model
Product Usage Instructions
Installation
- Ensure the power supply is turned off before installation.
- Refer to the installation manual for detailed instructions on connecting the terminals.
- Mount the Uponor Base flexiboard according to the provided guidelines.
Operation
- After installation, turn on the power supply and verify that the device is functioning correctly.
- Adjust the control settings as needed based on the desired temperature range.
Maintenance
- Regularly check for any signs of damage or wear and tear.
- Keep the device clean and free from dust accumulation.
- If any issues arise, refer to the troubleshooting section in the user manual.
FAQ
-
What should I do if the device is not heating up?
Check the power supply and ensure that the connections are secure. If the issue persists, contact customer support for further assistance. -
Can I use the device outdoors?
The suitability for outdoor use depends on the specific model and its IP rating. Refer to the product specifications or consult customer support for guidance. -
How can I adjust the temperature settings?
Refer to the user manual for instructions on adjusting the temperature settings. Typically, there are controls or settings on the device itself for this purpose.
TEMPERATURE CONTROL
INSTALLATION INSTRUCTION
SPECIFICATION
Safety instructions
The unit may only be opened by a qualified electrician and must be installed in accordance with the wiring diagram in the unit and these instructions. All applicable health and safety requirements must also be complied with. This is an electronic device connected to the mains for controlling thermostats and valves. It may only be used in dry and enclosed spaces under normal environmental conditions.