FISHER PAYKEL RSL030T-A Wireless Remote Control User Manual
- June 1, 2024
- Fisher & Paykel
Table of Contents
FISHER PAYKEL RSL030T-A Wireless Remote Control User Manual
Operating elements
- Indicator lamp
- Control keys
- ALL ON/ALL OFF key
- Battery compartment lid.
- RSL030T-B is without ALL ON/ALL OFF key
Inserting/replacing battery
- Remove the battery compartment lid (4) from the back of the remote control.
- Insert one round cell battery, type CR2032, into the battery recess. The positive pole face upward (see the “+” imprint on the battery). Push the battery all the way into the battery recess.
- Close the battery compartment. The battery must be replaced when the remote control’s range decreases noticeably or when the indicator lamp (1) no longer lights when a button is pushed.
Key functions
- The control keys (2) are arranged in two columns: left column = ON / right column = OFF
- Use the upper four keys on the left column to activate channels 1 to 4 individually.
- Use the upper four keys on the right column to deactivate channels 1 to 4 individually.
- Use the lower key ALL ON on the left column to activate channels 1 to 4 simultaneously.
- Use the lower key ALL OFF on the right column to deactivate channels 1 to 4 simultaneously. The indicator lamp (1) lights up each time a key is pressed.
Operation
Configuration and the dimming function will depend on your radio-controlled
power outlet. You can find detailed information in the operating instructions
of your radio-controlled power outlet. The remote control can control an
unlimited number of compatible radio-controlled power outlets.
Technical data
Battery type …………………………DC3V CR2032
Number of channels ……………..4 channels+ G channel
Transmission frequency…………433.92 MHz
Transmission range ………………max. 30 m (in open area)
Dimensions (W x H x D) ………..100 x 38x 13 mm
Weight ………………………………..33 g
WARNING
- INGESTION HAZARD : This product contains a button cell or coin battery.
- DEATH or serious injury can occur if ingested.
- A swallowed button cell or coin battery can cause Internal Chemical Burns in as little as 2 hours.
FCC statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation
This device has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This device generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this device does cause harmful interference to
radio or television reception, which can be determined by turning the device
off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the device and receiver.
- Connect the device into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>