ingenuity 12322-MEES Convert Me Swing 2 Seat Wimberly Owner’s Manual

ingenuity 12322-MEES Convert Me Swing 2 Seat Wimberly Owner’s Manual

PowerAdapt ConvertMe Swing-2-Seat™ – Wimberly™

Portable Swing • Columpio Portátil • Balançelle Portable
Tragbare Schaukel • Przenośna huśtawka • Altalena Portatile

IMPORTANT! READ CAREFULLY AND KEEP FOR FUTURE REFERENCE

FALL and STRANGULATION HAZARDS: Infants have suffered head injuries falling from swings and have strangled in straps.

• ALWAYS use the restraint system. Adjust to fit snugly.

•  STOP using product when infant attempts to climb out (approximately 9 months).

• In swing mode, DO NOT use this product once your child can sit up unaided or weighs more than 9 kg/20 lbs. DO NOT use this product if your child weighs less than 3kg/6 lbs. In stationary seat mode, stop using the product when baby starts trying to sit up.

• Stay near and watch baby during use. This product is not safe for sleep or unsupervised use. If baby falls asleep, remove baby as soon as possible and place baby on a firm, flat sleep surface such as a crib or bassinet.

• Never let the child sleep in this product.

• DO NOT move or lift this product with the baby inside it. Never lift product using a toy bar as a handle.

•  ALWAYS place product on floor. Never use this product on an elevated surface (e.g. a table).

• NEVER attach any additional strings or straps to product or toy bar.
  SUFFOCATION HAZARD: Babies have suffocated when seats tipped over on soft surfaces.

• NEVER use on a bed, sofa, cushion, or other soft surface.

Prevent Serious Injury or Death

• NEVER leave the child unattended.
• To avoid injury ensure that children are kept away when unfolding and folding this product.
• Do not let children play with this product.
• When using the USB cord, only use the one supplied with this swing.
• Check the USB cord and wall adaptor regularly for damage. Do not use if any damage has occurred.
• Use USB cord only with a 5 Volt/1 Amp (5 Watts) USB A wall adaptor.
• The product shall only be used with a transformer for toys.
• The transformer is not a toy.
• This product is only to be connected to equipment bearing either of the following symbols:
• Do not use extension cords.

• This product contains small parts. Adult assembly required.

IMPORTANT

• The provided USB cord is 183cm in length.
• This product contains magnets.
• Please read all instructions before assembly and use of the product.
• Care should be taken in unpacking and assembly.
• Examine product frequently for damaged, missing, or loose parts.
• DO NOT use if any parts are missing, damaged, or broken.
• Contact Kids2 for replacement parts and instructions if needed. Never substitute parts.
• This product does not replace a cot or a crib. Should the child fall asleep, then it should be placed in a suitable cot or crib.

Battery Information

The vibration unit requires (1) size C/LR14 (1.5V) alkaline batteries (not included).
CAUTION: Follow the battery guidelines in this section. Otherwise, battery
life may be shortened or the batteries may leak or rupture. To prevent battery leaks, which can burn skin and eyes:

• Always keep batteries away from children.
• Never mix old and new batteries, or batteries of different brands or types.
• Always replace the entire set of batteries at one time.
• Do not mix alkaline, standard, or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Install the batteries so that the polarity of each one matches the markings in the battery compartment.
• Do not short-circuit the batteries.
• Do not store batteries in areas that have extreme temperatures (such as attics, garages, or automobiles).
• Remove exhausted batteries from the battery compartment.
• Never attempt to recharge a battery unless it is specifically marked “rechargeable.”
• Rechargeable batteries are to be removed from the toy before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Dispose of used batteries immediately.
• Please use the correct disposal method for batteries.
• Remove batteries before putting the product into storage for a prolonged period of time.
• Weak batteries cause erratic product operation, including distorted sound, dimming or failed lights, and slow or non-working motorized parts. Because each electrical component requires a different operating voltage, replace the batteries when any function fails to operate.
• Do not dispose of product or batteries in fire, batteries may explode or leak.
  This symbol indicates that the product is not to be disposed of in household waste as batteries contain substances that can be damaging to the environment and health. Contact local authority for recycling & collection information.

Care and Cleaning

• Seat pad – Remove from frame. Fasten buckles on seat restraint and seat pad. Fasten all hook-and-loop patches to the corresponding patch. Machine wash with cold water, gentle cycle. No bleach. Tumble dry, using low heat.
• Headrest – Fasten all hook-and-loop patches. Machine wash with cold water, gentle cycle. No bleach. Air dry flat.
• Toy bar and toys – Wipe clean with a damp cloth and mild soap. Air dry. Do not immerse in water.
• Frame – Wipe the metal frame with a soft, clean cloth and mild soap.
• Storage – When putting swing away for storage, always store in a dry location, away from any heat sources, and out of the sun.

Parts List

Not included

Use USB cord only with a 5 Volt/1 Amp (5 Watts) USB A wall adaptor.

Use USB cord only with a 5 Volt/1 Amp (5 Watts) USB A wall adaptor.

Using in the Seat Mode

Using the Seat Restraint

Using the Swing Control Module

Using Swing Function

Storage and Travel

Using the Vibration Unit

To use the vibration function: Push the button to turn on or turn off the vibe unit.

FCC Statement/ CAN ICES-3 NMB-3(B )

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Find us on Facebook and Instagram @ingenuitybaby

ingenuitybaby.com

Read More About This Manual & Download PDF:

References

• Ingenuity™ – Kids2, LLC
• Kids2 Contact Us – Kids2, LLC

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>