FLAME SHADE FS4PB13 4 Pieces Base Stand Weight Set Instruction Manual

FLAME SHADE FS4PB13 4 Pieces Base Stand Weight Set

OFFSET UMBRELLA BASE WEIGHT SET 194lbs (88kgs)

PLEASE READ CAREFULLY AND RETAIN FOR FUTURE REFERENCE

SAFETY WARNING

This offset umbrella base weight set is designed to secure your offset umbrella in calm conditions only, where there is no breeze or wind.

• NEVER open or operate an offset patio umbrella in wind conditions greater than 5mph (8kph).
• NEVER use the umbrella tilt function in any wind (even a light breeze).
• ALWAYS close the umbrella when unattended or not in use. If you are not sitting under it, the umbral should be closed and secured.
• ALWAYS use storage straps to properly secure the canopy to the frame when the umbrella is closed.
• ALWAYS use a correctly weighted base for the size of the umbrella being used; more weight is always better than less weight.
  FAILURE TO CAREFULLY OBSERVE THESE SAFETY WARNINGS CAN RESULT IN DAMAGE TO YOUR UMBRELLA BASE, UMBRELLA, OR PROPERTY AND IN EXTREME CASES PERSONAL INJURY.

IMPORTANT INFORMATION

If the umbrella is showing ANY signs of stress, or IF the umbrella begins to move around excessively even when properly weighted it indicates the wind is too strong and the umbrella must be closed and secured immediately.

CARE AND MAINTENANCE

• During any extended periods of non-use, especially through the winter months your umbrella and the umbrella base should be stored inside in a dry place.
• Regular application of a plastic protectant to the base will help to protect it against damage from the harsh outdoor elements.

BEFORE YOU START

• Check you have all the listed parts before you start assembling.
• In the event of missing or damaged parts, contact our customer support team at fsesales@taijicrafts.com
• We suggest assembling on a soft surface such as a drop sheet or rug to avoid scratching.

PARTS LIST

ASSEMBLY INSTRUCTIONS

Step 1
Remove the plastic cap in each of the umbrella base weights and fill with sand and/or water, a small plastic funnel (not supplied) will make this job easier. Once filled, replace the cap. Approximate filled weight of the 4 pieces (combined) is:

MPORTANT NOTICE:

Temperatures below freezing will cause water to expand and may crack the base.
It is VERY IMPORTANT to add an anti-freeze mixture (follow the manufactures ratios) to the water inside the base (even if you use sand and water) if you choose to keep your base outdoors when temperatures are likely to fall below freezing. Failure to follow this step will damage the base if the water inside freezes and expands.

NOTE: If using a sand and water combination we suggest adding the sand first then adding the water.

Step 2
Place filled plastic umbrella base weights into the corners of the offset umbrella cross base.

CUSTOMER SUPPORT

Please reach out to our support team before leaving any negative review or feedback on Amazon.
Your complete satisfaction matters to us, so if our product hasn’t met or exceeded your expectations, or if
you are having problems with assembly, missing or damaged parts, before you do anything else please
email our support team directly, let us know the full details of the issue (attaching clear pictures to your
email will always help us to better understand exactly what’s gone wrong).
We promise to respond to your email within 24 hours, and we guarantee that we will fix the problem to
your complete satisfaction.
fsesales@taijicrafts.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>