AXXESS AXBUCH-T26V Toyota Back Up Camera Retain Add On Instruction Manual
- June 1, 2024
- AXXESS
Table of Contents
Installation Instructions for AXBUCH-T25V
AXBUCH-T26V
Toyota Back-Up Camera Retain/Add-On
2006-2013
INTERFACE FEATURES
- Retains the factory back-up camera to an aftermarket radio
- Allows an aftermarket camera to be added to the factory screen*
- Includes the AXCSD-6V 12-volt to 6-volt converter
- Display and navigation model radios only
INTERFACE COMPONENTS
- AXBUCH-T26V harness
- AXCSD-6V 12-volt to 6-volt converter
APPLICATIONS
TOYOTA
4-Runner (with a factory amp)| 2012-2013
4-Runner| 2006-2011
Avalon| 2011-2012
Camry| 2007-2011
Highlander| 2008-2012
Prius| 2010-2011
Sienna| 2008-2010
Sequoia (with a factory amp)| 2008-2012
Tundra (with a factory amp)| 2007-2013
Venza (with NAV)| 2009-2012
TOOLS REQUIRED
- Cutting tool
- Tape
- Crimping tool
- Connectors (example: butt connectors, bell caps, efc.)
CAUTION! All accessories, switches, climate controls panels, and especially air bag indicator lights must be connected before cycling the ignition. Also, do not remove the factory radio with the key in the on position, or while the vehicle is running.
Connections to be made
The AXBUCH-T26V can be connected two different ways
To retain the factory backup camera to an aftermarket radio:
- Connect the Black wire to chassis ground and also to the Black wire of the AXCSD-6V.
- Connect the Yellow wire to the Blue/Red wire of the AXCSD-6V.
- Connect the reverse wire from the aftermarket radio, to the reverse signal in the vehicle, and also to the Blue/White wire of the AXCSD-6V.
- Connect the male Yellow RCA jack to the rear camera input of the aftermarket radio.
- Disregard the loose Green/Purple wire, it will not be used in this application.
To allow an aftermarket camera to be added to the OEM screen:
- Connect the Black wire to the ground wire of the aftermarket camera.
- Connect the power wire of the aftermarket camera to accessory power.
- Tape off and disregard the Yellow wire, it will not be used in this application.
- Connect the female Yellow RCA jack to the aftermarket camera.
- The AXCSD-6V 12-volt to 6-volt converter will not be used in this application.
The following (2) steps are only required if a wire is not present in the factory harness.
- If a wire is not present in pin-5 of the 5-pin connector of the factory radio, unplug the connector, and then insert the metal pin of the loose Green/Purple wire into it. Connect the harness back into the radio.
- Connect the other end of the loose Green/ Purple wire to the reverse wire of the vehicle.
5 Pin Harness
This is the wire view of the connector in the vehicle
KNOWLEDGE IS POWER
Enhance your installation and fabrication skills by enrofing in the most
recognized and respected mobile electronics school in our industry.
Log onto www.installerinstitute.com or
cal 800-354-6782 for more information
and take steps toward a better tomorrow.
Metra recommends MECP certified technicians
Axxess Integrate
axxessinterfaces.com
metraonline.com
REV. 1/28/20
© COPYRIGHT 2020 METRA ELECTRONICS CORPORATION
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>