VISUAL COMFORT KSW1081 Monroe Tail Sconce Instruction Manual
- June 4, 2024
- VISUAL COMFORT
Table of Contents
VISUAL COMFORT KSW1081 Monroe Tail Sconce
GENERAL PRODUCT INFORMATION:
These fixtures are intended to be installed utilizing NEC compliant junction boxes.
This product is safety listed for damp locations. Incandescent version may be dimmed with a standard incandescent dimmer. LED version may be dimmed with a LED dimmer. Consult lamp manufacturer for additional information.
This instruction shows a typical installation.
CAUTION – RISK OF FIRE This product must be installed in accordance with
the applicable installation code by a person familiar with the construction
and operation of the product and the hazards involved.
Use minimum 90°c supply conductors.
SAVE THESE INSTRUCTIONS!
©2021 Visual Comfort & Co., L.L.C. All rights reserved. The Visual Comfort &
Co. logo is a registered trademark of Visual Comfort & Co. Visual Comfort &
Co. reserves the right to change specifications for product improvements
without notification.
7400 Linder Ave., Skokie, IL 60077
T 847.410.4400 | F 847.410.4500
www.generationlighting.com
Install the Fixture
- Secure the mounting plate to the junction box.
- Connect the fixture to a suitable ground in accordance to local electrical codes.
- Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
- Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
- Neatly place all the wires into the junction box, place the canopy onto the mounting plate, and secure it in place using the fixture screws.
- Screw the lamp(s) into the socket(s). Refer to the label on the lamp socket for Max Wattage information.
- Install the shade(s) by carefully placing them on to the lamp(s). Repeat for each socket.